beko dishwasher BDEN38523XQ manual

The Beko BDEN38523XQ is a freestanding dishwasher with a 13-place setting capacity, A++ energy rating, and multiple wash programs. It features a stainless steel interior, digital display, delay timer, child lock, half-load option, and AquaIntense technology for improved cleaning performance. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Care & Maintenance 9. Safety Information 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Stainless steel tub, upper and lower baskets, cutlery basket, detergent dispenser, digital display, control panel, water inlet and drain hoses.

Feature	Description
Capacity	13 place settings
Energy Rating	A++
AquaIntense Technology	Enhanced spray system for tough stains
Digital Display	Shows program time, settings, and errors
Delay Timer	Program start delay up to 24 hours
Child Lock	Prevents accidental program changes
Half Load Option	Eco wash for smaller loads
Wash Programs	Auto, Intensive, Eco, Quick, Glass, etc.
Dimensions (HxWxD)	85 x 60 x 60 cm
Noise Level	49 dB

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
Connect drain hose: Ensure proper height (40-100 cm from floor) to prevent siphoning.
Level the dishwasher: Adjust feet for stability.
Plug into grounded power outlet (220-240V, 50Hz).

WARNING! Only use hoses supplied. Do not kink hoses. Ensure electrical safety.

First-Time Setup

Before first use, run a wash cycle without dishes.

Remove packaging materials and transit bolts.
Add rinse aid to dispenser (fill until indicator shows full).
Add dishwasher salt to softener unit (if water hardness > 4°dH).
Select Intensive program and run empty cycle to clean interior.
Set water hardness level via program buttons (see manual).

CAUTION! Use only dishwasher detergents, salt, and rinse aids.

Specifications

Model: BDEN38523XQ
Type: Freestanding dishwasher
Capacity: 13 place settings
Energy Class: A++
Water Consumption: 10 L per cycle (Eco program)
Power Consumption: 0.78 kWh per cycle (Eco program)
Voltage/Frequency: 220-240V, 50Hz
Max Inlet Pressure: 1 MPa (10 bar)
Programs: Auto, Intensive (70°C), Eco (50°C), Quick (30 min), Glass, Hygiene
Special Features: Delay timer, child lock, half load, AquaIntense

Controls and Settings

Control Panel: POWER, PROGRAM SELECTION, DELAY START, CHILD LOCK, HALF LOAD, START/PAUSE.

Display Icons: Program time, delay timer, salt/rinse aid indicators, child lock, end of cycle.

Program Selection: Auto (senses soil level), Intensive (tough stains), Eco (energy saving), Quick (lightly soiled), Glass (delicate), Hygiene (sanitizes). Settings: Adjust water hardness (1-5), rinse aid dosage (1-5), acoustic signal on/off via button combinations (hold START + PROGRAM for 3 sec).

Loading the Dishwasher

Upper basket: Cups, glasses, small plates. Lower basket: Plates, pots, pans. Cutlery basket: Knives, forks, spoons.

Scrape off large food residues (no pre-rinsing needed).
Load dishes facing center spray arm; ensure no blockage.
Place delicate items in upper basket; secure tall items.
Add detergent to dispenser (check program for dosage).

Tip: Do not overload; allow water circulation. Place sharp items pointing down.

Using Wash Programs

Select program based on soil level and dish type.

Press POWER to turn on.
Select program with PROGRAM button (display shows duration).
Optional: Set delay timer (1-24 hrs) with DELAY button.
Press START/PAUSE to begin cycle; display counts down.
At end, acoustic signal sounds (if enabled); open door slightly to dry.
Turn off with POWER; unload lower basket first.

WARNING! Do not open door during hot cycles; steam may cause burns.

Care & Maintenance

Clean filters monthly: Remove lower basket, twist out filter assembly, rinse under tap. Wipe door seals and interior with damp cloth. Use dishwasher cleaner every 2 months to remove limescale.

CAUTION! Unplug before maintenance. Do not use abrasive cleaners.

Safety Information

Keep children away from open dishwasher. Do not sit or stand on door. Only use detergents for dishwashers. Ensure power cord is not damaged. In case of leak, turn off water and power immediately.

Regulatory Information

CE compliant. Meets EU Ecodesign and energy labeling regulations. Waste disposal: Follow local regulations for recycling. For support, visit www.beko.com or contact customer service at 0333 207 9710 (UK).

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dishwasher not starting	Power/door	Check plug, fuse; ensure door closed properly.
Poor cleaning results	Loading/detergent	Rearrange dishes; use correct detergent amount; clean filters.
Water not draining	Drain hose/filter	Check hose for kinks; clean filter; ensure drain height correct.
Display shows error code	Various faults	E1: Water inlet issue; E2: Drain problem; E3: Heating fault. Refer to manual.
Noise during operation	Spray arm/dishes	Ensure spray arms rotate freely; check for dish obstruction.

Reset: Turn off power for 5 minutes, then restart.

Service: 0333 207 9710; www.beko.com