beko dishwasher BDF1630X manual

The Beko BDF1630X is a freestanding dishwasher with a 13-place setting capacity, featuring an A++ energy rating, 5 wash programs, digital display, delay timer, child lock, and half-load option. It includes a cutlery basket, upper and lower baskets, rinse aid and salt indicators, and an AquaIntense system for improved cleaning. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Maintenance & Care 9. Safety Information 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel with digital display, upper and lower baskets, cutlery basket, filter system, salt and rinse aid compartments, inlet and drain hoses.

FeatureDescription
Capacity13 place settings
Energy RatingA++
Wash Programs5 programs (Intensive, Eco, Normal, Quick, Glass)
Digital DisplayShows program, time remaining, and status icons
Delay TimerProgram start delay up to 24 hours
Child LockPrevents accidental program changes
Half-Load OptionReduces water and energy for smaller loads
AquaIntense SystemEnhanced spray arm technology for better cleaning
Rinse Aid IndicatorAlerts when rinse aid is low
Salt IndicatorAlerts when water softener salt is low

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

  1. Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
  2. Connect drain hose: Place hose into sink or dedicated drain pipe (min height 40 cm).
  3. Level the dishwasher: Adjust feet to ensure machine is stable and level.
  4. Plug into grounded power outlet (220-240V, 50Hz).

WARNING! Ensure water and electrical connections are secure to prevent leaks or electrical hazards. Do not kink hoses.

First-Time Setup

Before first use, prepare the dishwasher.

  1. Remove transport materials: Take out any brackets or foam from inside.
  2. Fill salt dispenser: Add专用再生盐 to the softener unit (located at bottom of tub).
  3. Fill rinse aid dispenser: Add rinse aid to the compartment in the door.
  4. Run initial cycle: Select the Intensive program without dishes to clean interior.

CAUTION! Use only dishwasher salt and rinse aid. Do not use table salt.

Specifications

Controls and Settings

Control Panel: POWER, PROGRAM SELECTION, DELAY START, CHILD LOCK, HALF LOAD, START/PAUSE.

Display Icons: Program indicator, time remaining, salt low, rinse aid low, child lock active.

Program Selection: Press PROGRAM button to cycle through options. Delay Timer: Press DELAY to set start time (1-24 hours). Child Lock: Press and hold CHILD LOCK for 3 seconds to enable/disable. Half Load: Press HALF LOAD when baskets are not full to save resources. Start/Pause: Press to begin or interrupt a cycle.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

  1. Scrape off large food residues; pre-rinsing is not necessary.
  2. Lower basket: For plates, pots, pans. Adjustable rack height for larger items.
  3. Upper basket: For glasses, cups, saucers, small bowls.
  4. Cutlery basket: Place knives, forks, spoons; ensure sharp points face down.
  5. Do not block spray arms or detergent dispenser.

Tip: Refer to loading diagrams in the manual for optimal arrangement.

Using Wash Programs

Select program based on soil level and dish type.

  1. Add detergent: Use powder, tablet, or gel in main wash compartment.
  2. Select program: Intensive (heavily soiled), Eco (daily, energy-saving), Normal (standard), Quick (lightly soiled), Glass (fragile items).
  3. Optional: Set delay start or half load.
  4. Close door and press START/PAUSE.
  5. Cycle ends with beep; open door slightly to allow steam to escape.

WARNING! Use only dishwasher detergent. Do not use regular soap.

Maintenance & Care

Regular maintenance ensures longevity.

  1. Clean filter: Remove and rinse under water weekly.
  2. Check spray arms: Ensure holes are not clogged.
  3. Refill salt: When salt indicator lights, add专用再生盐 to softener unit.
  4. Refill rinse aid: When rinse aid indicator lights, fill compartment.
  5. Exterior cleaning: Wipe with damp cloth; do not use abrasive cleaners.

CAUTION! Unplug before any maintenance. Do not remove filter during cycle.

Safety Information

Read all safety instructions before use.

Regulatory Information

CE marked; complies with EU directives for safety and electromagnetic compatibility. Energy label according to EU regulation 1059/2010. Waste electrical products should not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.beko.com or contact customer service.

Troubleshooting

SymptomPossible CauseCorrective Action
Dishwasher won't startPower/doorCheck power connection; ensure door is fully closed.
Poor cleaning resultsLoading/detergentReload dishes properly; use correct amount of fresh detergent.
Water not drainingFilter/drain hoseClean filter; check drain hose for kinks or blockages.
Unusual noiseSpray arm/foreign objectCheck for items blocking spray arm; remove any foreign objects.
Salt/Rinse Aid indicator onLow levelRefill salt or rinse aid compartment.
Leaking waterHose connectionsTighten inlet and drain hose connections; check door seal for damage.

Reset: Unplug for 5 minutes, then restart.

Service: Contact authorized Beko service center. Do not attempt repairs yourself.

beko dishwasher BDF1630X manual © - All Rights Reserved 2025