Beko Dishwasher BDFN15421S Manual

The Beko BDFN15421S is a 15-place setting freestanding dishwasher featuring an A++ energy rating, 5 wash programs, digital display, half-load option, adjustable upper basket, salt and rinse aid indicators, child lock, and delay start timer. Designed for standard 60cm width installation. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Detergents & Additives 8. Care & Maintenance 9. Safety Information 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel with digital display, upper and lower baskets, cutlery basket, filter system, detergent dispenser, salt container, rinse aid dispenser.

FeatureDescription
Energy RatingA++ for high energy efficiency
Place Settings15 standard place settings capacity
Wash Programs5 programs: Intensive, Eco, Normal, Rapid, Glass
Digital DisplayShows program duration, remaining time, and status icons
Half Load OptionReduces water and energy for smaller loads
Adjustable Upper BasketHeight adjustable for taller items
Salt & Rinse Aid IndicatorsLED indicators for low levels
Child LockPrevents accidental program changes
Delay StartTimer up to 24 hours
Acoustic SignalOptional end-of-cycle beep

Installation

Unpack and inspect contents. Ensure location is level, near water supply, drain, and power outlet.

  1. Position dishwasher: Slide into 60cm wide space, leaving clearance at rear and sides.
  2. Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
  3. Connect drain hose: Ensure proper height (40-100 cm from floor) to prevent siphoning.
  4. Level the appliance: Adjust front feet for stability.
  5. Connect to power: Plug into grounded 220-240V, 50Hz outlet.

WARNING! Ensure water and electrical connections are secure before first use. Do not kink hoses.

First-Time Setup

Before first wash, prepare the dishwasher.

  1. Fill salt container: Remove lower basket, unscrew cap, add 1 kg of dishwasher salt, then refill with water until it overflows.
  2. Fill rinse aid dispenser: Open lid on door, pour rinse aid up to MAX mark.
  3. Select program: Run an empty cycle with detergent to clean interior.
  4. Adjust water hardness: Set hardness level via program button sequence (see manual).

CAUTION! Use only dishwasher salt and rinse aid. Do not use table salt.

Specifications

Controls and Settings

Control Panel: ON/OFF button, Program selection buttons, Delay Start, Half Load, Child Lock, Start/Pause.

Programs: Intensive (70°C), Eco (50°C), Normal (65°C), Rapid (45°C, 30 min), Glass (40°C).

Settings: Delay Start (1-24 hrs), Half Load (activates for upper basket only), Child Lock (press and hold Start for 3 sec), Acoustic Signal (enable/disable via button combination). Display shows program time, remaining time, salt/rinse aid indicators, and error codes.

Loading the Dishwasher

For optimal cleaning, load items correctly.

  1. Scrape off large food residues; no need to pre-rinse.
  2. Lower basket: Pots, pans, lids, plates (facing center).
  3. Upper basket: Glasses, cups, small plates, bowls.
  4. Cutlery basket: Place knives, forks, spoons; mix types for separation.
  5. Adjust upper basket: Lift to high position for tall items.
  6. Ensure spray arms rotate freely; do not block with large items.

Tip: Place delicate items in upper basket, heavily soiled items facing spray arms.

Using Detergents & Additives

Use only dishwasher-specific products.

  1. Detergent: Fill main dispenser with powder, tablet, or gel. Use amount per water hardness.
  2. Rinse Aid: Adjust dispenser setting (1-5) based on water spotting; higher for hard water.
  3. Salt: Refill when indicator lights; prevents limescale on heater.
  4. Combination tablets: Place in main dispenser; ensure they dissolve properly.

WARNING! Do not use hand soap, laundry detergent, or vinegar. Keep products out of reach of children.

Care & Maintenance

Regular maintenance ensures performance and longevity.

  1. Clean filter: Remove lower basket, twist and lift out filter assembly, rinse under tap weekly.
  2. Clean spray arms: Remove and check for blockages in nozzles.
  3. Wipe door seals: Use damp cloth to remove debris.
  4. Descale: Run empty cycle with dishwasher cleaner every 2 months if in hard water area.
  5. Exterior: Clean with mild soap and damp cloth.

CAUTION! Unplug before maintenance. Do not use abrasive cleaners or steam.

Safety Information

Read all instructions before use.

WARNING! Risk of electric shock if used improperly. Do not immerse in water.

Regulatory Information

CE marked; complies with EU directives for low voltage, electromagnetic compatibility, and eco-design. Manufactured by Beko PLC. For EU product registration, visit beko.com/registration. Waste electrical products must not be disposed of with household waste; recycle according to local regulations. For support, visit www.beko.com or contact local service center.

Troubleshooting

SymptomPossible CauseCorrective Action
Dishwasher not startingPower, door, child lockCheck plug, fuse, ensure door closed, deactivate child lock.
Poor cleaning resultsLoading, detergent, filterRearrange load, use correct detergent amount, clean filter.
Water not drainingDrain hose, filter blockageCheck hose for kinks, clean filter, ensure drain height correct.
Salt indicator flashingLow saltRefill salt container; reset indicator by pressing Program 1 & 3 for 3 sec.
Leaking waterHose connections, door sealTighten inlet/drain hoses, check seal for debris, ensure door closed properly.
Unusual noiseSpray arm, foreign objectCheck for items blocking spray arm, remove debris from pump area.

Reset: Unplug for 5 minutes, then restart.

Service: Contact authorized Beko service center. Find at www.beko.com.

Beko Dishwasher BDFN15421S Manual © - All Rights Reserved 2025