Beko Dishwasher BDFN15430X Manual

The Beko BDFN15430X is a 15-place setting freestanding dishwasher with an A++ energy rating, featuring 6 wash programs, a half-load option, adjustable upper basket, salt and rinse aid indicators, delay timer, child lock, and AquaIntense technology for stubborn stains. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Care & Maintenance 9. Safety Information 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel, Upper and lower baskets, Cutlery basket, Filter system, Salt container, Rinse aid dispenser, Water inlet and drain hoses.

FeatureDescription
Energy RatingA++ (Energy efficient)
Place Settings15 standard place settings
Wash Programs6 programs including Intensive, Eco, Quick, Glass, etc.
Half Load OptionReduces water and energy for smaller loads
Adjustable Upper BasketHeight adjustable for taller items
Salt & Rinse Aid IndicatorsLED indicators for refill reminders
Delay TimerProgram start delay up to 24 hours
Child LockPrevents accidental program changes
AquaIntense TechnologyTargeted spray for tough stains
DisplayDigital display with remaining time

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

  1. Position dishwasher: Place in desired location, ensuring stability and leveling.
  2. Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
  3. Connect drain hose: Ensure proper height (min 40 cm, max 100 cm from floor).
  4. Electrical connection: Plug into grounded 220-240V, 50Hz outlet.
  5. Remove transit bolts: Located at rear; use spanner to remove before use.

WARNING! Do not install near heat sources. Ensure all connections are secure and leak-free.

First-Time Setup

Before first use, prepare dishwasher and set basic functions.

  1. Fill salt container: Remove lower basket, unscrew salt cap, fill with 1 kg dishwasher salt, replace cap.
  2. Fill rinse aid: Open dispenser on door, fill to MAX line, close securely.
  3. Run initial cycle: Select Intensive program without dishes to clean interior.
  4. Adjust water hardness: Set according to local water hardness (see manual table).
  5. Set language: If applicable, select display language via settings.

CAUTION! Use only dishwasher salt and rinse aid. Do not mix with detergents.

Specifications

Controls and Settings

Control Panel: POWER, Program selection buttons, Delay Timer, Half Load, Start/Pause, Child Lock.

Programs: Intensive (70°C), Eco (50°C), Quick (45 min), Glass (40°C), Auto, Rinse.

Settings: Water hardness (1-5), Rinse aid dosage (1-4), Buzzer on/off, Reset filter indicator.

Operation: Press POWER, select program, add options if needed, press START/PAUSE. Display shows remaining time.

Loading the Dishwasher

Proper loading ensures optimal cleaning and prevents damage.

  1. Scrape off large food residues; no pre-rinsing needed.
  2. Lower basket: Plates, pots, pans (face center).
  3. Upper basket: Glasses, cups, small bowls (angled downward).
  4. Cutlery basket: Place mixed with handles down; spoons separated.
  5. Adjust upper basket: Lift to higher position for tall items.
  6. Ensure spray arms rotate freely; do not block with large items.

Tip: Place delicate items in upper basket, heavily soiled items facing spray arms.

Using Wash Programs

Select program based on load type and soil level.

  1. Add detergent: Fill main wash compartment; use tablet in detergent dispenser.
  2. Select program: Press POWER, choose program via buttons.
  3. 3. Add options: Half Load for fewer items, Delay Timer for delayed start.
  4. Start: Close door firmly, press START/PAUSE.
  5. During cycle: Display shows remaining time; door locks automatically.
  6. After cycle: Wait for beep; open door slightly to allow steam escape; unload.

WARNING! Use only dishwasher detergents. Do not open door during hot cycles.

Care & Maintenance

Regular maintenance ensures longevity and performance.

  1. Clean filter: Twist and lift out filter assembly; rinse under tap weekly.
  2. Clean spray arms: Remove and check for blockages; rinse monthly.
  3. Check salt level: Refill when indicator lights (approx. every 20 cycles).
  4. Check rinse aid: Refill when indicator lights.
  5. Exterior cleaning: Wipe with damp cloth; no abrasive cleaners.
  6. Run empty cycle: Monthly with dishwasher cleaner to remove grease.

CAUTION! Unplug before maintenance. Do not use sharp objects on spray arms.

Safety Information

Read all instructions before use. Keep children away from open dishwasher.

Regulatory Information

CE marked; complies with EU directives. Waste electrical products must not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.beko.com or contact local service center. Model BDFN15430X manufactured by Beko Plc.

Troubleshooting

SymptomPossible CauseCorrective Action
Dishwasher not startingDoor not closed/powerEnsure door closed firmly; check power outlet; press POWER.
Poor cleaning resultsLoading/detergent/filterCheck loading; use correct detergent amount; clean filter.
Water not drainingDrain hose blockedCheck hose for kinks/blockages; clean filter.
Salt indicator onSalt lowRefill salt container; run short cycle to flush.
Unusual noiseSpray arm blockedCheck for items blocking spray arms; remove obstructions.
Error codes (E1, E2, etc.)Various faultsSee manual error code list; reset by unplugging for 5 min.

Reset: Unplug for 5 minutes, then restart.

Service: Contact authorized Beko service; www.beko.com

Beko Dishwasher BDFN15430X Manual © - All Rights Reserved 2025