beko dishwasher BDFN15431W manual

The Beko BDFN15431W is a 15-place setting freestanding dishwasher with an A++ energy rating, featuring 7 wash programs, a digital display, half-load function, adjustable upper basket, salt and rinse aid indicators, and a delay start timer. It operates on a standard 220-240V, 50Hz power supply. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Care & Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Digital control panel, adjustable upper basket, cutlery basket, filter system, salt and rinse aid dispensers, inlet and drain hoses.

FeatureDescription
Energy RatingA++ for high energy efficiency
Place Settings15 standard place settings capacity
Wash Programs7 programs including Intensive, Eco, Quick, and Glass
Digital DisplayShows program duration, remaining time, and status icons
Half-Load FunctionReduces water and energy consumption for smaller loads
Adjustable Upper BasketHeight adjustable for taller items in lower basket
Salt & Rinse Aid IndicatorsLED lights alert when refills are needed
Delay Start TimerProgram start delay from 1 to 24 hours
Child LockPrevents accidental program changes
Acoustic SignalOptional end-of-cycle beep

Installation

Unpack and inspect contents. Position near water supply, drain, and power outlet.

  1. Connect water supply: Attach inlet hose to cold water tap using supplied connector.
  2. Connect drain hose: Place hose into sink or dedicated drain pipe, ensure no kinks.
  3. Level the appliance: Adjust feet using a spanner to ensure stability.
  4. Plug into power outlet: Use a properly grounded 220-240V, 50Hz socket.

WARNING! Ensure water and electrical connections are secure before first use. Do not bend or crush hoses.

First-Time Setup

Before first wash, prepare the dishwasher.

  1. Fill salt dispenser: Open cap, pour in special dishwasher salt until full, then tighten cap.
  2. Fill rinse aid dispenser: Open flap on door, pour rinse aid up to MAX mark, close flap.
  3. Run initial empty cycle: Select Intensive program without dishes to clean interior.
  4. Set water hardness: Consult manual table; use PROGRAM + HALF LOAD buttons to set level (1-5).

CAUTION! Use only dishwasher salt and rinse aid. Table salt will damage the appliance.

Specifications

Controls and Settings

Control Panel: ON/OFF button, Program selection buttons, Delay Start, Half Load, Start/Pause, Child Lock.

Program Guide: Intensive (70°C, heavily soiled), Auto (45-65°C, daily use), Eco (50°C, energy saving), Quick 60' (60°C, lightly soiled), Delicate (40°C, fragile items), Glass (40°C, glasses only), Pre-Rinse (cold, for holding).

Settings: Use PROGRAM + HALF LOAD to set water hardness (1-5). Use RINSE AID button to adjust rinse aid dosage (1-4). Child Lock: Press and hold CHILD LOCK for 3 seconds to activate/deactivate.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

  1. Scrape off large food residues; pre-rinsing is not necessary.
  2. Lower basket: For plates, pots, pans. Place items facing center, not touching.
  3. Upper basket: For glasses, cups, small bowls. Adjust height if needed.
  4. Cutlery basket: Place knives pointing down, spoons and forks mixed.
  5. Ensure spray arms can rotate freely; do not block with large items.

Tip: Refer to loading diagrams in manual for best results.

Using Wash Programs

Select program based on soil level and item type.

  1. Turn on: Press ON/OFF.
  2. Load dishes and add detergent to dispenser.
  3. Select program: Press corresponding program button.
  4. Optional: Press DELAY to set start time (1-24h), HALF LOAD for smaller loads.
  5. Start: Close door firmly; press START/PAUSE. Display shows remaining time.
  6. After cycle: Wait for end signal; open door slightly to let steam escape before unloading.

WARNING! Use only dishwasher detergent. Do not open door during wash cycle.

Care & Maintenance

Regular maintenance ensures longevity.

  1. Clean filter: Twist and lift out filter assembly weekly, rinse under tap.
  2. Clean spray arms: Remove and check for blockages monthly.
  3. Check salt and rinse aid: Refill when indicator lights illuminate.
  4. Exterior cleaning: Wipe with damp cloth; do not use abrasive cleaners.
  5. Run empty hot cycle with dishwasher cleaner every 2 months.

CAUTION! Unplug before any maintenance. Never remove filter during operation.

Regulatory Information

This appliance complies with EU Directives 2014/35/EU (LVD), 2014/30/EU (EMC), and 2009/125/EC (ErP). Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist. Check local regulations for disposal. For support, visit www.beko.com or contact your local Beko service center.

Troubleshooting

SymptomPossible CauseCorrective Action
Dishwasher won't startDoor not closed/powerEnsure door is firmly closed; check power outlet and fuse.
Poor cleaning resultsLoading/detergent/filterImprove loading; use correct detergent amount; clean filter.
Water not drainingDrain hose blocked/kinkedCheck hose for kinks/blockages; clean filter.
Salt indicator stays onSalt empty/incorrect settingRefill salt; check water hardness setting.
Unusual noiseSpray arm obstructedCheck for items blocking spray arm rotation.
Error code on displayVarious faultsConsult manual error code list; try resetting by turning power off/on.

Reset: Turn off at mains for 2 minutes, then restart.

Service: Contact authorized Beko service. Do not attempt repairs yourself.

beko dishwasher BDFN15431W manual © - All Rights Reserved 2025