Beko Dishwasher BDFN26440XC Manual

The Beko BDFN26440XC is a 24-inch built-in dishwasher with 14 place settings, 7 wash programs, delay start, half load option, child lock, and energy-efficient features. It includes a stainless steel interior, adjustable upper rack, cutlery basket, and rinse aid/salt indicators. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Maintenance & Cleaning 9. Safety Features 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel, spray arms, filter system, detergent dispenser, rinse aid dispenser, salt container, adjustable racks, cutlery basket.

Feature	Description
Capacity	14 place settings
Wash Programs	7 programs including Intensive, Eco, Quick, Glass
Delay Start	Programmable delay up to 24 hours
Half Load Option	Reduces water and energy for smaller loads
Child Lock	Locks control panel during operation
Adjustable Upper Rack	Height adjustable for taller items
Filter System	Self-cleaning filter with coarse and fine filters
Salt Container	For water softening (if required)
Rinse Aid Indicator	LED indicates when rinse aid is low
Energy Rating	A++ energy efficiency class

Installation

Unpack and inspect contents. Ensure proper electrical and plumbing connections.

Position dishwasher: Place in cabinet cutout (24-inch width).
Connect water supply: Attach inlet hose to hot water connection (max 140°F).
Connect drain hose: Ensure proper drainage to sink or disposal.
Electrical connection: Plug into grounded 120V outlet (dedicated circuit recommended).
Level the unit: Adjust feet for stability.

WARNING! Installation must comply with local codes. Use only recommended hoses and fittings.

First-Time Setup

Before first use, run a wash cycle without dishes.

Remove shipping materials: Check interior for protective tapes and remove.
Fill salt container: If water hardness > 17°dH, fill with dishwasher salt.
Fill rinse aid dispenser: Open cap and fill until indicator shows full.
Run initial cycle: Select Intensive program without dishes to clean interior.
Set water hardness: Use settings menu to match local water hardness.

CAUTION! Do not use detergent in salt container. Use only dishwasher-specific products.

Specifications

Dimensions (HxWxD): 33.9" x 23.6" x 22.8" (built-in).
Capacity: 14 place settings.
Water Consumption: Approx. 2.9 gallons per Eco cycle.
Energy Consumption: 0.78 kWh per Eco cycle.
Noise Level: 49 dB (A).
Water Pressure: 20-116 psi required.
Power Supply: 120V, 60Hz, 15A.
Programs: Intensive, Eco, Quick 30', Glass, Rinse, Auto, Hygiene.
Warranty: 2 years parts and labor.

Controls and Settings

Control Panel: POWER, PROGRAM SELECTION, DELAY START, HALF LOAD, CHILD LOCK, START/PAUSE.

Program Selection: Intensive (heavily soiled), Eco (normal, energy-saving), Quick 30' (lightly soiled), Glass (delicate), Rinse (rinse only), Auto (sensor-based), Hygiene (high temperature).

Settings: Water hardness adjustment (1-5), rinse aid dosage (1-6), acoustic signal on/off, reset filter indicator. Use PROGRAM + POWER buttons for 3 seconds to access settings menu.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

Scrape off large food residues before loading.
Lower rack: Pots, pans, plates, cutlery basket.
Upper rack: Glasses, cups, bowls, delicate items.
Adjust upper rack height: Lift levers on both sides to raise/lower.
Ensure spray arms rotate freely and items do not block them.
Place cutlery with handles down for safety.

Tip: Do not overload. Place heavily soiled items facing center spray arm.

Using Wash Programs

Select program based on soil level and dish type.

Add detergent: Fill main wash compartment; use pre-wash for heavily soiled loads.
Select program: Press PROGRAM repeatedly to cycle through options.
Start: Close door firmly and press START/PAUSE.
During cycle: Press START/PAUSE to pause; child lock activates automatically.
End of cycle: Acoustic signal sounds (if enabled); door unlocks after cool-down.

WARNING! Use only dishwasher detergents. Do not open door during high-temperature cycles.

Maintenance & Cleaning

Regular maintenance ensures performance and longevity.

Clean filter: Twist and lift filter assembly; rinse under warm water weekly.
Clean spray arms: Remove and check for clogs; rinse holes.
Wipe door seals: Use damp cloth to remove residue.
Descale: Run empty cycle with dishwasher cleaner every 2-3 months if in hard water area.
Check salt and rinse aid: Refill as indicated by LEDs.

CAUTION! Unplug before maintenance. Do not use abrasive cleaners on interior.

Safety Features

Child Lock: Press and hold CHILD LOCK for 3 seconds to activate/deactivate. Door lock: Automatically locks during wash cycles; unlocks after cool-down. Overflow protection: Float switch stops water if detected. Thermal protection: Prevents overheating.

Regulatory Information

UL listed; complies with NSF/ANSI 184 for residential dishwashers. Energy Star certified. Manufactured by Beko. For support, visit www.bekousa.com or contact 1-866-332-8456. Copyright © 2023 Beko. All rights reserved.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dishwasher won't start	Power/door	Check power outlet; ensure door closed firmly; child lock off.
Poor cleaning results	Loading/detergent	Check spray arms for blockage; use correct detergent amount; clean filter.
Water not draining	Drain hose/filter	Check drain hose for kinks; clean filter; ensure proper installation height.
Leaking water	Door seal/hose	Check door seal for debris; ensure hoses connected tightly.
Noise during operation	Spray arm/items	Ensure spray arms rotate freely; check for items touching interior.
Salt/Rinse Aid LED on	Low level	Refill salt container or rinse aid dispenser.

Reset: Unplug for 5 minutes, then restart.

Service: 1-866-332-8456; www.bekousa.com