beko dishwasher BDFN26530W manual

The Beko BDFN26530W is a freestanding dishwasher with a 14-place setting capacity, A++ energy rating, and 5 wash programs. It features a stainless steel interior, digital display, delay start function, half-load option, and child lock. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Stainless steel tub, upper and lower baskets, cutlery basket, detergent dispenser, digital display, control panel.

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

1. Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
2. Connect drain hose: Ensure proper height (40-100 cm from floor) to prevent siphoning.
3. Level the appliance: Adjust feet to ensure dishwasher is stable and level.
4. Plug into grounded power outlet (220-240V, 50Hz).

WARNING! Ensure water and electrical connections are secure to prevent leaks or electrical hazards. Do not kink hoses.

First-Time Setup

Before first use, prepare the dishwasher.

1. Remove shipping materials: Check interior for any transit bolts or packaging.
2. Fill salt container: If water hardness >5°dH, fill with dishwasher salt (first use may require water in container).
3. Fill rinse aid dispenser: Adjust dial (1-6) based on water hardness and drying preference.
4. Run initial empty cycle: Select Intensive program without dishes to clean interior.

CAUTION! Use only dishwasher-specific salt, rinse aid, and detergent. Do not use regular table salt.

Specifications

• Model: BDFN26530W
• Type: Freestanding Dishwasher
• Capacity: 14 place settings
• Energy Class: A++
• Water Consumption: Approx. 10 liters per cycle (Eco program)
• Power Consumption: 0.95 kWh per cycle (Eco program)
• Noise Level: 49 dB(A)
• Dimensions (HxWxD): 85 x 60 x 60 cm
• Voltage/Frequency: 220-240V, 50Hz
• Programs: Intensive, Eco, Quick (30 min), Delicate, Mixed

Controls and Settings

Control Panel: POWER button, Program selection buttons, Delay Start, Half Load, Child Lock, Start/Pause.

Program Selection: Press corresponding button (Intensive, Eco, Quick, Delicate, Mixed). Digital display shows program duration and status.

Delay Start: Press DELAY to set start time (1-24 hours).

Half Load: Press HALF LOAD when washing fewer dishes (uses less water and energy).

Child Lock: Press and hold CHILD LOCK for 3 seconds to activate/deactivate.

Rinse Aid Adjustment: Turn dial inside dispenser (1=lowest dosage, 6=highest).

Loading the Dishwasher

Proper loading ensures optimal cleaning.

1. Scrape off large food residues; no need to pre-rinse.
2. Lower basket: For plates, pots, pans. Adjust height if needed.
3. Upper basket: For glasses, cups, small bowls. Tilt glasses for secure placement.
4. Cutlery basket: Place knives, forks, spoons with handles down (except sharp knives).
5. Detergent: Add powder or tablet to dispenser. Close lid firmly.

Tip: Do not overload. Ensure spray arms can rotate freely and water reaches all items.

Using Wash Programs

Select program based on soil level and dish type.

1. Load dishes and add detergent.
2. Select program via control panel.
3. Optional: Set Delay Start or Half Load.
4. Press START/PAUSE to begin cycle. Display shows remaining time.
5. After completion, wait a few minutes before unloading to avoid steam burns.

WARNING! Do not open door during hot wash phases. Use handle to avoid contact with hot surfaces.

Care & Maintenance

Regular maintenance ensures longevity.

1. Clean filters: Remove lower basket, twist and lift out filter assembly. Rinse under water weekly.
2. Clean spray arms: Check for blockages; remove if necessary to clear debris.
3. Exterior: Wipe with damp cloth; do not use abrasive cleaners.
4. Door seals: Wipe clean to prevent mold.
5. Monthly: Run empty cycle with dishwasher cleaner or vinegar to remove grease/limescale.

CAUTION! Unplug before any maintenance. Do not use sharp objects to clean filters or spray arms.

Regulatory Information

This appliance complies with EU Directives 2014/35/EU (LVD), 2014/30/EU (EMC), and 2009/125/EC (ErP). Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist. Check local regulations for disposal of packaging material. For support, visit www.beko.com or contact your local Beko service center.

Troubleshooting

Reset: Turn off power at mains for 5 minutes, then restart.

Service: For persistent issues, contact authorized Beko service: www.beko.com/support.