Beko Dishwasher BDFN26640WC Manual

The Beko BDFN26640WC is a 60cm wide, freestanding dishwasher with a stainless steel interior, 14-place setting capacity, and an A++ energy rating. It features 6 wash programs (including Eco, Intensive, and Quick), a half-load option, a delay timer, a salt and rinse aid indicator, and child lock. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Stainless steel tub, upper and lower baskets, cutlery basket, control panel, detergent dispenser, salt container, rinse aid dispenser, filters, spray arms.

Installation

Unpack and inspect contents. Ensure location is level, near water inlet, drain, and power outlet.

1. Remove transit materials: Take out all packaging and securing bolts from the rear.
2. Connect water inlet: Attach the supplied hose to a cold water tap (max pressure 1 MPa).
3. Connect drain hose: Place hose into sink or dedicated drain pipe (min height 40 cm, max 100 cm).
4. Level the appliance: Adjust the feet to ensure the dishwasher is stable and level.
5. Plug into power: Connect to a grounded 220-240V, 50Hz outlet.

WARNING! Installation must comply with local regulations. Only use hoses supplied with the appliance.

First-Time Setup

Before first use, prepare the dishwasher for operation.

1. Fill the salt container: Unscrew cap, pour in 1 kg of special dishwasher salt, then fill with water until it overflows. Tighten cap.
2. Fill the rinse aid dispenser: Open lid, fill to MAX line with rinse aid, close lid.
3. Run an empty wash: Select the Intensive program without dishes to clean the interior and remove any residue.
4. Set water hardness: Consult the manual table and set the hardness level using the program buttons (if applicable).

CAUTION! Only use salt specifically designed for dishwashers. Do not use table salt.

Specifications

• Model: BDFN26640WC
• Type: Freestanding
• Width: 60 cm
• Capacity: 14 place settings
• Energy Consumption (Eco): 0.83 kWh/cycle
• Water Consumption (Eco): 9.5 L/cycle
• Noise Level: 49 dB(A)
• Supply Voltage: 220-240V ~ 50Hz
• Rated Power Input: 2000 W
• Programs: Eco, Intensive, Quick (30 min), Glass, Auto, Rinse
• Special Functions: Half Load, Delay Timer (1-24h), Child Lock

Controls and Settings

Access controls via the front panel. Main buttons: POWER ON/OFF, PROGRAM SELECTION, HALF LOAD, DELAY START, CHILD LOCK, START/PAUSE.

Program Selection: Press repeatedly to cycle through Eco, Intensive, Quick, Glass, Auto, Rinse. The selected program light will illuminate.

Half Load: Press to activate for washing only the upper basket. Light will turn on.

Delay Start: Press to set delay (1-24 hours). Display shows countdown to start.

Child Lock: Press and hold for 3 seconds to activate/deactivate. Prevents button presses during operation.

Start/Pause: Press to start the selected program. Press again to pause.

Loading the Dishwasher

For optimal cleaning, load items correctly.

1. Scrape off large food residues. Pre-rinsing is not necessary.
2. Lower Basket: Place pots, pans, plates, and larger items. Ensure spray arms can rotate freely.
3. Upper Basket: Place glasses, cups, saucers, and smaller plates. Use the fold-down cup shelves.
4. Cutlery Basket: Place knives, forks, spoons, and utensils with handles down (except sharp knives). Mix items to prevent nesting.
5. Do not overload. Ensure water can reach all surfaces.

Tip: Refer to the loading diagrams in the manual for best results.

Using Detergents and Additives

Use only detergents and additives designed for dishwashers.

1. Detergent: Fill the main wash compartment (marked I) in the dispenser door. For short programs, you may also use the pre-wash compartment (marked II). Use the amount recommended on the detergent packaging.
2. Rinse Aid: The dispenser is filled separately. Adjust the dosage setting (1-6) via the dial inside the dispenser lid. Higher numbers release more rinse aid for harder water or to reduce spotting.
3. Salt: Only required if your water is hard (above 6°dH). The salt container is in the bottom of the tub. Refill when the salt indicator light comes on.

WARNING! Do not mix different types of detergent (powder, tablet, gel). Keep all detergents out of reach of children.

Care & Cleaning

Regular maintenance ensures long life and optimal performance.

1. Clean the exterior: Wipe with a damp, soft cloth. Do not use abrasive cleaners.
2. Clean the interior: Remove and rinse the filters weekly under running water. Wipe the door seals and interior with a damp cloth.
3. Clean the spray arms: Check for blockages in the holes and rinse under water.
4. Descale: If in a hard water area, run an empty cycle with a dishwasher descaler every few months.

CAUTION! Unplug the appliance before cleaning. Do not use steam cleaners.

Safety Information

Read all instructions before use.

• This appliance can be used by children aged 8 years and above and persons with reduced capabilities if they have been given supervision or instruction concerning safe use.
• Do not allow children to play with the appliance.
• Keep the door closed when not in use to prevent tripping.
• Do not open the door during a wash cycle, as hot steam may escape.
• Sharp items (knives) should be placed with the handles up.
• Check that the detergent dispenser is empty after the cycle completion.

Regulatory Information

This appliance complies with EU Directives 2014/35/EU (Low Voltage), 2014/30/EU (EMC), and 2009/125/EC (Ecodesign). The declaration of conformity is available from the manufacturer. For disposal, follow local regulations for electrical and electronic equipment (WEEE). Do not dispose of with household waste. For support, visit www.beko.com or contact your local Beko service center.

Troubleshooting

Reset: Turn off power at the socket for 5 minutes, then restart.

Service: For repairs, contact an authorized Beko service technician. Do not attempt to repair yourself.