beko dishwasher BDFS26046XQ manual

The Beko BDFS26046XQ is a freestanding dishwasher with a 12-place setting capacity, featuring multiple wash programs, energy efficiency class A, delay start function, child lock, and a stainless steel interior. It offers quiet operation, various temperature settings, and rinse aid/salt indicators. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Care & Maintenance 9. Safety Information 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel, Spray arms, Filter system, Cutlery basket, Detergent dispenser, Rinse aid dispenser, Salt container.

FeatureDescription
12 Place SettingsCapacity for up to 12 standard place settings
Energy Class AEnergy efficient operation
Delay StartProgram start delay up to 24 hours
Child LockSafety lock for control panel
Quiet OperationLow noise level during wash cycles
Stainless Steel InteriorDurable and hygienic interior tub
Multiple Wash ProgramsIncludes Intensive, Eco, Quick, Glass, etc.
Half Load OptionEco wash for smaller loads
Rinse Aid IndicatorAlerts when rinse aid is low
Salt IndicatorAlerts when water softener salt is low

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

  1. Connect water supply: Attach inlet hose to water tap (max pressure 1 MPa).
  2. Connect drain hose: Ensure proper height (40-100 cm from floor) to prevent siphoning.
  3. Level the dishwasher: Adjust feet for stability.
  4. Plug into grounded power outlet (220-240V, 50Hz).

WARNING! Ensure water and electrical connections are secure to prevent leaks or electrical hazards. Follow local plumbing codes.

First-Time Setup

Before first use, prepare the dishwasher.

  1. Remove transport materials: Check interior for any packing strips or foam.
  2. Fill salt container: Add water softener salt (only for hard water areas).
  3. Fill rinse aid dispenser: Adjust dosage level (1-4) based on water hardness.
  4. Run initial empty cycle: Select Intensive program without dishes to clean interior.
  5. Set water hardness: Use control panel to match local water hardness level.

CAUTION! Use only dishwasher-specific salt and rinse aid. Do not use table salt.

Specifications

Controls and Settings

Control Panel: POWER ON/OFF, Program selection buttons, Delay Start, Half Load, Child Lock, Start/Pause.

Programs: Intensive (70°C), Eco (50°C), Quick (45°C), Glass (40°C), Pre-Rinse (cold).

Settings: Adjust rinse aid dosage (1-4), set water hardness (1-5), activate child lock (press and hold Child Lock for 3 seconds). Delay Start: Set delay from 1 to 24 hours. Half Load: Reduces water and energy for smaller loads.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

  1. Lower basket: For plates, bowls, and larger items.
  2. Upper basket: For glasses, cups, and smaller dishes.
  3. Cutlery basket: Place cutlery with handles down (except sharp knives).
  4. Spray arm clearance: Ensure items do not block spray arms.
  5. Pre-rinse: Scrape off large food residues; no need to pre-wash.

Tip: Place delicate items in upper basket, facing downward. Avoid nesting items.

Using Wash Programs

Select program based on load type and soil level.

  1. Add detergent: Use powder, tablet, or gel in dispenser (check compartment for pre-wash/main wash).
  2. Select program: Press program button until desired program light is on.
  3. Optional settings: Set Delay Start or Half Load if needed.
  4. Start: Press Start/Pause; door locks automatically.
  5. Program end: Audible signal sounds; "End" appears on display.
  6. Unloading: Wait a few minutes after cycle to avoid steam burns; unload lower basket first.

WARNING! Only open door after cycle completes or when paused. Use only dishwasher-safe detergents.

Care & Maintenance

Regular maintenance ensures longevity.

  1. Clean filters: Remove and rinse under water weekly.
  2. Clean spray arms: Check for blockages monthly.
  3. Wipe door seals: Clean with damp cloth to prevent leaks.
  4. Descale: Run empty cycle with dishwasher cleaner every 2-3 months (if in hard water area).
  5. Check salt and rinse aid: Refill as indicated by lights.

CAUTION! Unplug before maintenance. Do not use abrasive cleaners on interior.

Safety Information

Read all instructions before use. Keep children away from open door (hot surfaces). Do not wash items soiled with flammable substances. Ensure door is closed during operation. Disconnect power before servicing.

WARNING! Risk of electric shock. Do not immerse appliance in water. Only qualified personnel should repair.

Regulatory Information

This appliance complies with EU Directive 2014/35/EU (Low Voltage Directive) and 2014/30/EU (EMC Directive). Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist. Check local regulations for disposal. For support, visit www.beko.com or contact customer service.

Troubleshooting

SymptomPossible CauseCorrective Action
Dishwasher not startingPower supply, door not closedCheck plug/power; ensure door is firmly closed.
Poor cleaning resultsOverloading, wrong detergent, clogged filterLoad correctly; use recommended detergent; clean filter.
Water not drainingDrain hose blocked/kinkedCheck hose for blockages; ensure proper height.
Leaking waterDoor seal damaged, overfillingCheck seal; ensure no overuse of detergent.
Noise during operationSpray arm hitting items, foreign objectsRearrange load; check for small objects in pump.
Salt/Rinse Aid light onLow salt/rinse aidRefill respective container.

Reset: Turn off power for 5 minutes, then restart.

Service: Contact authorized Beko service center. Do not attempt repairs yourself.

beko dishwasher BDFS26046XQ manual © - All Rights Reserved 2025