beko dishwasher BDIN16430 manual

The Beko BDIN16430 is a built-in dishwasher with 14 place settings, energy efficiency class A, 6 wash programs, half-load option, adjustable upper basket, salt and rinse aid indicators, delay start function, child lock, and acoustic signal. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Maintenance 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel with digital display, upper and lower baskets, cutlery basket, filter system, detergent dispenser, salt container, rinse aid dispenser.

Feature	Description
Place settings	14 standard place settings capacity
Energy class	A-rated for energy efficiency
Wash programs	6 programs including Intensive, Eco, Quick, Glass, etc.
Half-load option	Reduces water and energy for smaller loads
Adjustable upper basket	Height adjustable for taller items
Salt indicator	LED indicates when to refill water softener salt
Rinse aid indicator	LED indicates when to refill rinse aid
Delay start	Programmable delay up to 24 hours
Child lock	Prevents accidental program changes
Acoustic signal	Audible signal when program ends

Installation

Unpack and inspect contents. Ensure installation space meets requirements.

Position dishwasher: Place in built-in cabinet space (60cm width standard).
Connect water supply: Attach inlet hose to cold water tap (max pressure 1MPa).
Connect drain hose: Ensure proper drainage into sink or waste pipe.
Connect to power: Plug into grounded 220-240V, 50Hz outlet.
Level the appliance: Adjust feet for stability.

WARNING! Installation must be performed by qualified personnel. Ensure water and electrical connections are secure to prevent leaks and hazards.

First-Time Setup

Before first use, prepare the dishwasher.

Remove transport materials: Take out all packaging and securing items inside.
Fill salt container: Add dishwasher salt to the softener unit (first use requires water in container).
Fill rinse aid dispenser: Pour rinse aid up to MAX mark.
Run initial cycle: Select Intensive program without dishes to clean interior.
Set water hardness: Adjust softener setting according to local water hardness.

CAUTION! Use only dishwasher salt and rinse aid. Do not use table salt or other substitutes.

Specifications

Type: Built-in dishwasher.
Capacity: 14 place settings.
Energy class: A.
Water consumption: Approx. 11 liters per Eco cycle.
Power consumption: Approx. 0.95 kWh per Eco cycle.
Programs: 6 wash programs + options.
Dimensions (HxWxD): 82 x 60 x 55 cm.
Voltage/Frequency: 220-240V, 50Hz.
Max inlet water pressure: 1 MPa (10 bar).
Min inlet water pressure: 0.03 MPa (0.3 bar).

Controls and Settings

Control panel includes program selector, start/pause button, delay button, half-load button, child lock button, and digital display with indicators.

Programs: Intensive (70°C), Eco (50°C), Normal (65°C), Quick (45°C), Glass (40°C), Rinse.

Options: Half-load (reduces consumption), Delay start (1-24h), Child lock (press 3 sec to activate).

Indicators: Salt refill, rinse aid refill, program progress, end signal.

Settings menu: Access by holding two buttons (varies by model) to set water hardness, acoustic signal on/off, etc.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

Scrape off large food residues; no need to pre-rinse.
Lower basket: For plates, pots, pans. Adjustable rack for larger items.
Upper basket: For glasses, cups, small plates. Height adjustable.
Cutlery basket: Place knives, forks, spoons with handles down for safety.
Detergent: Use only dishwasher detergent in dispenser (powder, tablets, or gel).

Tip: Do not overload; ensure spray arms can rotate freely. Place delicate items in upper basket.

Using Wash Programs

Select program based on load type and soil level.

Load dishes and add detergent.
Close door firmly.
Add options: Press half-load or delay if needed.
Start: Press start/pause button; display shows remaining time.
Pause: Press start/pause during cycle to interrupt; press again to resume.
End of cycle: Acoustic signal sounds; display shows "End."
Unloading: Wait a few minutes after cycle to avoid steam burns; unload lower basket first.

WARNING! Do not open door during hot wash phases; hot steam may cause burns.

Maintenance

Regular maintenance ensures performance and longevity.

Filter cleaning: Clean coarse and fine filters weekly under running water.
Spray arms: Check monthly for clogs; clean holes with toothpick if blocked.
Salt refill: Refill when salt indicator lights; use only dishwasher salt.
Rinse aid refill: Refill when indicator lights; adjust dosage via dial inside dispenser.
Door seal: Wipe clean periodically to prevent mold.

Descaling: Use dishwasher descaler every 2-3 months if in hard water area.

Care & Cleaning

Unplug before cleaning exterior. Use mild detergent and soft cloth; avoid abrasives.

Interior: Run empty cycle with dishwasher cleaner monthly. Exterior: Wipe with damp cloth; dry immediately.

CAUTION! Do not use steam cleaners; avoid water on control panel. Never use harsh chemicals or solvents.

Regulatory Information

CE compliant; meets EU energy labeling and ecodesign requirements. Waste electrical products must not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.beko.com or contact local Beko service center.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dishwasher not starting	Power/door	Check power supply; ensure door closed properly; child lock may be active.
Poor cleaning results	Loading/detergent	Check loading; ensure spray arms not blocked; use correct detergent amount.
Water not draining	Filter/drain hose	Clean filter; check drain hose for kinks or blockages.
Leaking water	Door seal/hose	Check door seal for debris; ensure hoses properly connected and undamaged.
Unusual noise	Spray arm/foreign object	Check for items obstructing spray arm; remove foreign objects from pump area.
Salt indicator on	Salt empty	Refill salt container; ensure salt cap tightly closed.

Reset: Unplug for 5 minutes, then reconnect to reset electronic control.

Service: Contact authorized Beko service; do not attempt repairs yourself.