beko dishwasher BDIN38550C manual

The Beko BDIN38550C is a freestanding dishwasher with a 14-place setting capacity, A++ energy rating, and multiple wash programs. It features a stainless steel interior, digital display, delay timer, child lock, and half-load option. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Stainless steel tub, upper and lower baskets, cutlery basket, detergent dispenser, digital display, control panel.

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

1. Connect water supply: Attach inlet hose to water tap (max pressure 1 MPa).
2. Connect drain hose: Place in sink or connect to waste pipe (min height 40 cm).
3. Level the dishwasher: Adjust feet to ensure stability.
4. Plug into grounded power outlet (220-240V, 50Hz).

WARNING! Do not use extension cords. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first use, run a wash cycle without dishes.

1. Fill salt container: Remove lower basket, unscrew cap, add 1 kg of dishwasher salt.
2. Fill rinse aid: Open dispenser, fill to MAX line, close securely.
3. Add detergent: Place powder or tablet in dispenser.
4. Select Intensive program and start cycle.

CAUTION! Use only dishwasher-specific salt, rinse aid, and detergent.

Specifications

• Model: BDIN38550C
• Type: Freestanding dishwasher
• Capacity: 14 place settings
• Energy Rating: A++
• Water Consumption: 10 L per cycle (Eco program)
• Power Consumption: 0.78 kWh per cycle (Eco program)
• Noise Level: 49 dB
• Dimensions (HxWxD): 85 x 60 x 60 cm
• Voltage: 220-240V, 50Hz
• Programs: Auto, Intensive (70°C), Eco (50°C), Quick (30 min), Glass, Delicate

Controls and Settings

Control Panel: POWER, PROGRAM SELECTION, DELAY START, HALF LOAD, CHILD LOCK, START/PAUSE.

Display: Shows selected program, remaining time, delay timer status, and error codes.

Program Selection: Auto (senses soil level), Intensive (heavy soil), Eco (energy saving), Quick (light soil), Glass (crystal), Delicate (fine china). Delay Timer: Set wash start up to 24 hours later. Half Load: Use for fewer dishes. Child Lock: Press and hold CHILD LOCK for 3 seconds to enable/disable.

Loading the Dishwasher

Upper basket: For glasses, cups, saucers. Lower basket: For plates, bowls, pots. Cutlery basket: For knives, forks, spoons.

1. Scrape off large food residues.
2. Load dishes facing inward, not touching.
3. Place delicate items in upper basket.
4. Ensure spray arms can rotate freely.

Tip: Do not overload; water must reach all surfaces.

Using Wash Programs

Select program based on soil level and dish type.

1. Add detergent: Fill dispenser (check program guide for amount).
2. Close door: Ensure it latches securely.
3. Select program: Press PROGRAM until desired cycle lights up.
4. Optional: Set DELAY START or HALF LOAD.
5. Press START/PAUSE to begin; display shows remaining time.
6. After cycle ends, wait 2 minutes before opening door (steam hazard).

WARNING! Do not open door during wash cycle; hot water may spray out.

Care & Maintenance

Clean exterior with damp cloth; clean filters monthly.

1. Unplug dishwasher.
2. Remove lower basket and twist out filter assembly.
3. Rinse filters under warm water; remove debris.
4. Reassemble and replace.
5. Run empty wash cycle with dishwasher cleaner every 3 months.

CAUTION! Do not use abrasive cleaners or sharp objects on interior.

Safety Information

Keep children away during operation. Do not wash items soiled with flammable substances. Only connect to grounded outlet. Disconnect power before maintenance.

Regulatory Information

CE marked; complies with EU directives for safety and electromagnetic compatibility. Energy label according to EU regulation 1059/2010. For support, visit www.beko.com or contact local service center.

Troubleshooting

Reset: Turn off power for 5 minutes, then restart.

Service: Contact authorized Beko service center; www.beko.com