beko dishwasher BDIN38660C manual

The Beko BDIN38660C is a freestanding dishwasher with a 14-place setting capacity, A++ energy rating, 3-in-1 AquaIntense technology, 7 wash programs, digital display, delay start, child lock, and half-load option. It features a stainless steel interior, adjustable upper basket, cutlery basket, and salt/rinse aid indicators. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Maintenance 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Digital control panel, stainless steel tub, upper and lower baskets, cutlery basket, filter system, salt and rinse aid compartments.

FeatureDescription
Capacity14 place settings
Energy RatingA++ (energy efficient)
AquaIntense Technology3-in-1 system for intensive cleaning
Wash Programs7 programs including Eco, Intensive, Quick
Digital DisplayShows remaining time and program status
Delay StartProgrammable up to 24 hours
Child LockPrevents accidental program changes
Half Load OptionSaves water and energy for smaller loads
Adjustable Upper BasketHeight adjustable for larger items
Salt & Rinse Aid IndicatorsLED alerts for refilling

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

  1. Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
  2. Connect drain hose: Place in sink or connect to waste pipe (min height 40 cm).
  3. Level the dishwasher: Adjust feet until unit is stable and level.
  4. Plug into grounded power outlet (220-240V, 50Hz).

WARNING! Ensure water and electrical connections are secure before first use. Do not kink hoses.

First-Time Setup

Before first wash, prepare the dishwasher.

  1. Fill salt container: Remove lower basket, unscrew cap, add 1 kg of dishwasher salt, then refill with water until it overflows.
  2. Fill rinse aid: Open dispenser on door, fill to MAX line with rinse aid.
  3. Run initial empty cycle: Select Intensive program without dishes to clean interior.
  4. Set water hardness: Use program button combination to match local water hardness (see manual).

CAUTION! Use only dishwasher salt and rinse aid. Do not mix with detergents.

Specifications

Controls and Settings

Control Panel: ON/OFF button, Program selector, Delay Start, Half Load, Child Lock, Start/Pause.

Programs: Eco (energy saving), Intensive (tough stains), Quick (30 min), Glass (delicate), Auto (sensor-based), Hygiene (high temperature), Rinse (no detergent).

Settings: Delay Start (1-24 hours), Child Lock (press and hold Start for 3 seconds), Half Load (press Half Load button when loading only one basket). Display shows remaining time, program stage, and salt/rinse aid alerts.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

  1. Scrape off large food residues before loading.
  2. Lower basket: For pots, pans, plates, and larger items.
  3. Upper basket: For glasses, cups, saucers, and smaller items (height adjustable).
  4. Cutlery basket: Place knives, forks, spoons with handles down (except sharp knives).
  5. Add detergent: Use powder, tablet, or gel in dispenser (check program compatibility).

Tip: Do not overload; ensure spray arms can rotate freely. Place delicate items in upper basket.

Using Wash Programs

Select program based on load type and soil level.

  1. Turn on: Press ON/OFF button.
  2. Select program: Turn program selector to desired program (Eco recommended for daily use).
  3. Add options: Press Delay Start or Half Load if needed.
  4. Start: Close door and press Start/Pause (door locks automatically).
  5. After cycle: Wait for cycle end beep; open door slightly to let steam escape before unloading.

WARNING! Do not open door during hot wash phases; hot steam may cause burns.

Maintenance

Regular maintenance ensures longevity.

Care & Cleaning

Unplug before cleaning exterior. Wipe control panel and door with damp cloth; do not use abrasive cleaners.

CAUTION! Do not use steam cleaners; avoid water on control panel. Clean rubber door seal regularly to prevent mold.

Regulatory Information

CE marked; complies with EU directives for safety and electromagnetic compatibility. Energy label according to EU regulation 1059/2010. Waste electrical products must not be disposed of with household waste; recycle according to local regulations. For support, visit www.beko.com or contact local service center.

Troubleshooting

SymptomPossible CauseCorrective Action
Dishwasher not startingPower/doorCheck power supply; ensure door is closed properly.
Poor cleaning resultsLoading/detergentCheck spray arms for blockages; use correct detergent dose; ensure filter is clean.
Water not drainingDrain hose/filterCheck drain hose for kinks; clean filter; ensure drain height is correct.
Noise during operationSpray arm/itemsEnsure spray arms rotate freely; check dishes are not obstructing spray arms.
Salt indicator remains onSalt level/settingsRefill salt container; check water hardness setting is correct.
Leaking waterHose connectionsTighten inlet and drain hose connections; check door seal for debris.

Reset: Turn off at mains for 5 minutes, then restart.

Service: Contact authorized Beko service center; have model number ready.

beko dishwasher BDIN38660C manual © - All Rights Reserved 2025