beko dishwasher BDIS38041Q manual

The Beko BDIS38041Q is a freestanding dishwasher with a 14-place setting capacity, energy rating A, featuring 6 wash programs (including Eco, Intensive, and Quick), delay start function, child lock, half load option, and salt and rinse aid indicators. It operates on 220-240V, 50Hz power supply. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Maintenance 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control Panel, Upper and Lower Baskets, Cutlery Basket, Filter System, Salt Container, Rinse Aid Dispenser, Inlet and Drain Hoses.

Feature	Description
Control Panel	Digital display with program selection buttons
Upper Basket	Adjustable height for plates and glasses
Lower Basket	For pots, pans, and larger items
Cutlery Basket	Removable basket for utensils
Filter System	Self-cleaning filter for food particles
Salt Container	For water softening (regeneration salt)
Rinse Aid Dispenser	Adjustable dispenser for spot-free drying
Delay Start	Program start delay up to 24 hours
Child Lock	Locks control panel during operation
Half Load	Eco option for fewer dishes

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

Connect water inlet: Attach inlet hose to water tap (max pressure 1 MPa).
Connect drain hose: Place hose into sink or drain pipe (min height 40 cm).
Level the dishwasher: Adjust feet until unit is stable and level.
Plug into power outlet (220-240V, 50Hz).

WARNING! Ensure water connections are tight to prevent leaks. Use only recommended hoses.

First-Time Setup

Before first use, prepare the dishwasher.

Fill salt container: Remove lower basket, unscrew salt cap, fill with 1 kg of regeneration salt, then tighten.
Fill rinse aid: Open dispenser on door, fill to MAX line, close.
Run initial wash: Select Intensive program without dishes to clean interior.
Set water hardness: Use program button combination to set according to local water hardness (1-5).

CAUTION! Only use salt specifically for dishwashers. Do not use table salt.

Specifications

Capacity: 14 place settings.
Energy Rating: A.
Water Consumption: Approx. 11 liters per cycle (Eco program).
Power Consumption: 0.78 kWh per cycle (Eco program).
Noise Level: 49 dB.
Programs: 6 (Eco, Intensive, Normal, Quick, Glass, Rinse).
Dimensions (HxWxD): 85 x 60 x 60 cm.
Power Supply: 220-240V, 50Hz.
Weight: 42 kg.

Controls and Settings

Control Panel: ON/OFF button, Program Selection buttons (Eco, Intensive, etc.), Delay Start, Child Lock, Half Load, Start/Pause.

Indicator Lights: Salt indicator, Rinse Aid indicator, End of cycle.

Program Selection: Press desired program button (light will illuminate). Delay Start: Press Delay button, then use +/- to set hours (1-24). Child Lock: Press and hold Start/Pause for 3 seconds. Half Load: Press Half Load button before starting cycle for reduced water usage.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

Scrape off large food residues (no pre-rinsing required).
Lower Basket: Place pots, pans, lids, and large plates facing center.
Upper Basket: Place glasses, cups, small plates, and bowls.
Cutlery Basket: Place utensils with handles down (except sharp knives).
Ensure spray arms can rotate freely; do not block with large items.

Tip: Place delicate items in upper basket, heavily soiled items facing spray arms.

Using Wash Programs

Select program based on soil level and dish type.

Eco: For normally soiled dishes (energy efficient, longer cycle).
Intensive: For heavily soiled pots and pans (high temperature).
Normal: Daily wash for mixed load.
Quick: 30-minute cycle for lightly soiled dishes.
Glass: Gentle wash for crystal and delicate glassware.
Rinse: Rinse only (no detergent) for holding dishes.

Add detergent to dispenser, close door, select program, press Start/Pause. Cycle ends with beep; open door slightly to aid drying.

Maintenance

Regular maintenance ensures performance and longevity.

Clean Filter: Twist and lift out filter assembly weekly, rinse under tap.
Check Spray Arms: Ensure holes are not clogged; remove and rinse if needed.
Refill Salt: When salt indicator lights, add regeneration salt (only to salt container).
Refill Rinse Aid: When rinse aid indicator lights, fill dispenser to MAX.
Door Seals: Wipe clean with damp cloth to prevent mold.

Care & Cleaning

Unplug before cleaning exterior. Use mild detergent and soft cloth; avoid abrasives.

CAUTION! Do not use steam cleaners; never clean with flammable fluids.

Regulatory Information

CE marked; complies with EU directives for safety and electromagnetic compatibility. Energy label according to EU regulation 1059/2010. Waste electrical products must not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.beko.com or contact local service center.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dishwasher not starting	Power/door	Check plug and power; ensure door is closed properly.
Poor cleaning results	Loading/detergent	Rearrange load; use correct amount of fresh detergent; clean filter.
Water not draining	Drain hose clogged	Check drain hose for kinks; clean filter; ensure drain height is correct.
Leaking water	Hose connections	Tighten inlet/drain hoses; check door seal for debris.
Unusual noise	Spray arm obstruction	Check for items blocking spray arms; ensure baskets are properly seated.
Salt indicator on	Salt container empty	Fill salt container with regeneration salt.

Reset: Turn off at power for 2 minutes, then restart.

Service: Contact authorized Beko service; www.beko.com