beko dishwasher BDSN36540XP manual

The Beko BDSN36540XP is a freestanding dishwasher with a 14-place setting capacity, featuring an A++ energy rating, 5 wash programs, half-load function, delay timer up to 24 hours, child lock, salt and rinse aid indicators, and AquaIntense technology for improved cleaning. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Control panel, Upper and lower baskets, Cutlery basket, Filter system, Salt container, Rinse aid dispenser, Water inlet and drain hoses.

Installation

Unpack and inspect contents. Ensure location is near water inlet, drain, and power outlet.

1. Position dishwasher: Place on level floor near water and drain connections.
2. Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
3. Connect drain hose: Ensure proper height (40-100 cm from floor) to prevent siphoning.
4. Electrical connection: Plug into grounded 220-240V, 50Hz outlet. Do not use extension cord.
5. Level the appliance: Adjust feet to ensure stability.

WARNING! Installation must comply with local regulations. Only use certified hoses. Ensure power is disconnected during installation.

First-Time Setup

Before first use, prepare the dishwasher.

1. Remove transport materials: Take out all packaging and securing items from interior.
2. Fill salt container: Unscrew cap, add 1 liter of water, then fill with dishwasher salt. Tighten cap.
3. Fill rinse aid dispenser: Open lid, fill to MAX line, close lid.
4. Run empty cycle: Select Intensive program without dishes to clean interior and remove residues.
5. Set water hardness: Use program button combination to set according to local water hardness.

CAUTION! Only use dishwasher salt in the salt container. Do not use table salt.

Specifications

• Model: BDSN36540XP
• Type: Freestanding dishwasher
• Capacity: 14 place settings
• Energy Consumption: 0.95 kWh per cycle (Eco program)
• Water Consumption: 10 liters per cycle (Eco program)
• Noise Level: 49 dB(A)
• Programs: Intensive (70°C), Eco (50°C), Quick (45°C), Glass (40°C), Auto
• Delay Timer: 3, 6, 9 hours or up to 24 hours in 1-hour increments
• Power Supply: 220-240V, 50Hz
• Water Pressure: 0.03 - 1 MPa

Controls and Settings

Control Panel: POWER button, Program selection buttons, Delay Timer button, Half-Load button, Child Lock button, Start/Pause button.

Display Icons: Program indicator, Delay time, Salt indicator, Rinse aid indicator, Child lock, End of cycle.

Program Selection: Press PROGRAM button to cycle through options. Delay Timer: Press DELAY button, then use PROGRAM to set hours. Half-Load: Press HALF button before starting cycle for upper basket only. Child Lock: Press and hold CHILD LOCK for 3 seconds to activate/deactivate. To start: Load dishes, add detergent, select program, press START/PAUSE.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

1. Scrape off large food residues before loading.
2. Upper basket: For cups, glasses, small plates, and plastic items.
3. Lower basket: For plates, pots, pans, and larger items.
4. Cutlery basket: Place knives, forks, spoons with handles down (except sharp knives).
5. Ensure items do not block spray arms and can move freely.
6. Load according to manufacturer's instructions for plastics and delicate items.

Tip: Refer to loading diagrams on inner door for optimal arrangement.

Using Detergents and Additives

Use only dishwasher-specific products.

1. Detergent: Fill main detergent dispenser according to water hardness and soil level (15-25g). Use tablets if compatible.
2. Rinse aid: Fill dispenser to MAX line. Adjust dosage level via dial inside dispenser (1-6).
3. Salt: Only for hard water areas. Fill salt container when indicator lights.
4. Combination detergents (3-in-1): Follow manufacturer's instructions. May eliminate need for separate salt/rinse aid.

WARNING! Do not use regular washing-up liquid. Keep all detergents out of reach of children.

Care & Cleaning

Regular maintenance ensures longevity.

1. Clean exterior: Use soft cloth with mild detergent. Do not use abrasive cleaners.
2. Clean interior: Remove and clean filter weekly under running water.
3. Clean spray arms: Check for blockages monthly.
4. Run empty hot cycle: Monthly with dishwasher cleaner to remove grease and limescale.
5. Door seals: Wipe clean to prevent mold.

CAUTION! Unplug before cleaning. Do not use steam cleaners.

Regulatory Information

CE marked. Complies with EU directives for low voltage, electromagnetic compatibility, and eco-design. Waste electrical products must not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.beko.com or contact your local Beko service center.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: Contact authorized Beko service: www.beko.com/support