Beko Dishwasher DFN 1001 X Manual

The Beko Dishwasher DFN 1001 X is a freestanding dishwasher with a 10-place setting capacity, featuring energy efficiency class A, multiple wash programs, delay start function, child lock, salt and rinse aid indicators, and adjustable upper basket. Designed for standard kitchen installation with dimensions H85 x W60 x D60 cm. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Control panel with digital display, Upper and lower baskets, Cutlery basket, Filter system, Salt container, Rinse aid dispenser, Water inlet and drain hoses.

Installation

Unpack and inspect contents. Position near water supply and drain.

1. Connect water inlet: Attach inlet hose to cold water tap (max pressure 1 MPa).
2. Connect drain hose: Place hose into sink or connect to waste pipe (min height 40 cm).
3. Level the appliance: Adjust feet to ensure dishwasher is level and stable.
4. Plug into grounded power outlet (220-240V, 50Hz).

WARNING! Ensure water and electrical connections are secure before first use. Do not kink hoses.

First-Time Setup

Before first wash, prepare the dishwasher.

1. Fill salt container: Remove lower basket, unscrew salt cap, fill with 1 kg special dishwasher salt, tighten cap.
2. Fill rinse aid dispenser: Open dispenser on door, fill to MAX line, close lid.
3. Run initial empty cycle: Select Intensive program without dishes to clean interior.
4. Set water hardness: Use program button combination to set according to local water hardness (1-5).

CAUTION! Only use dishwasher salt in salt container. Do not use table salt.

Specifications

• Model: DFN 1001 X
• Type: Freestanding dishwasher
• Capacity: 10 place settings
• Energy Consumption: 0.95 kWh per cycle (Eco program)
• Water Consumption: 12 liters per cycle (Eco program)
• Noise Level: 49 dB(A)
• Dimensions (HxWxD): 85 x 60 x 60 cm
• Voltage/Frequency: 220-240V, 50Hz
• Power: 2000 W
• Programs: Intensive, Eco, Quick 30', Glass, Delicate, Soak

Controls and Settings

Control Panel: ON/OFF button, Program selector, Delay Start button, Half Load button, Child Lock button, Salt and Rinse Aid indicators.

Program Selection: Turn knob to select: Intensive (70°C), Eco (50°C), Quick 30' (45°C), Glass (40°C), Delicate (40°C), Soak (pre-wash).

Delay Start: Press button, use program knob to set delay 1-24 hours. Half Load: Reduces water for fewer dishes. Child Lock: Press and hold for 3 seconds to lock controls. Indicators: Light up when salt or rinse aid needs refilling.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

1. Scrape off large food residues (no pre-rinsing needed).
2. Lower basket: Pots, pans, lids, plates (facing center).
3. Upper basket: Glasses, cups, small bowls, plastic items.
4. Cutlery basket: Forks, knives, spoons (handles down), separate silver from stainless steel.
5. Adjust upper basket: Lift to higher position for taller items.
6. Ensure spray arms rotate freely; do not block with large items.

Tip: Place delicate items in upper basket, heavily soiled items facing spray arms.

Using Wash Programs

Select program based on soil level and dish type.

1. Turn on: Press ON/OFF button.
2. Select program: Turn knob to desired program.
3. Add options: Press Half Load if needed; set Delay Start if desired.
4. Start: Close door firmly; cycle begins automatically.
5. During cycle: Display shows remaining time; door locks for safety.
6. End of cycle: Acoustic signal sounds; display shows "END".
7. Unloading: Wait 10 minutes after cycle for dishes to cool; remove from lower basket first.

WARNING! Do not open door during hot wash phases; steam may cause burns.

Maintenance & Cleaning

Regular maintenance ensures performance and longevity.

1. Clean filter weekly: Remove lower basket, twist filter assembly counterclockwise, rinse under tap.
2. Clean spray arms monthly: Remove by pulling upwards, check nozzles for blockages.
3. Wipe door seals: Use damp cloth to remove food residues.
4. Descale monthly: Run empty cycle with dishwasher cleaner or vinegar.
5. Refill salt: When salt indicator lights, add 1 kg dishwasher salt (only in salt container).
6. Refill rinse aid: When indicator lights, fill dispenser to MAX line.

CAUTION! Unplug before maintenance. Do not use abrasive cleaners.

Safety Features

Child Lock: Locks control panel to prevent accidental program changes. Door Lock: Automatically locks during wash cycles. Overflow Protection: Float switch stops water if level too high. Thermal Cut-out: Prevents overheating.

Regulatory Information

CE marked: Complies with European safety and EMC directives. Energy label: Class A according to EU regulation 1059/2010. Waste disposal: Comply with local regulations; contact municipality for recycling. For support, visit www.beko.com or contact customer service at 0333 207 9710 (UK).

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: 0333 207 9710; www.beko.com