Beko Dishwasher DIN 4420 Manual

The Beko Dishwasher DIN 4420 is a high-efficiency built-in dishwasher designed for standard kitchen cabinetry. It features multiple wash programs, energy-saving modes, adjustable racks, a salt and rinse aid system, child lock, delay start, and a digital display. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: Control Panel, Upper and Lower Racks, Cutlery Basket, Filter System, Salt Container, Rinse Aid Dispenser, Inlet and Drain Hoses.

Installation

Unpack and inspect contents. Ensure proper space and connections.

1. Position dishwasher: Slide into standard 60cm cabinet opening under countertop.
2. Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
3. Connect drain hose: Place into sink or dedicated drain pipe (min height 40cm).
4. Electrical connection: Plug into grounded 220-240V, 50Hz outlet.
5. Level the appliance: Adjust feet to ensure stability.

WARNING! Installation must be performed by qualified personnel. Ensure water and electrical connections are secure to prevent leaks and hazards.

First-Time Setup

Before first use, prepare the dishwasher.

1. Remove transport materials: Take out all packaging and securing brackets inside.
2. Fill salt container: Unscrew cap, add 1 liter of water, then fill with special dishwasher salt.
3. Fill rinse aid: Open dispenser, fill to MAX line, set dial to position 3.
4. Run initial cycle: Select Intensive program without dishes to clean interior.
5. Set water hardness: Consult manual table; set hardness level via program buttons.

CAUTION! Use only dishwasher salt and rinse aid. Do not use table salt or other substitutes.

Specifications

• Type: Built-in, under counter.
• Place Settings: 13 place settings standard.
• Energy Rating: A++ (Energy Label).
• Water Consumption: Approx. 10 liters per Eco cycle.
• Power Consumption: 0.95 kWh per Eco cycle.
• Dimensions (HxWxD): 82 x 59.8 x 55 cm.
• Voltage/Frequency: 220-240V, 50Hz.
• Max Inlet Water Pressure: 1 MPa (10 bar).
• Min Inlet Water Pressure: 0.03 MPa (0.3 bar).
• Noise Level: 48 dB(A).

Controls and Settings

Control Panel: ON/OFF, Program Selection (Auto, Intensive, Eco, Quick, Glass, Delicate), Delay Start, Half Load, Child Lock, Start/Pause.

Display Icons: Program indicator, Delay time, Salt alert, Rinse aid alert, Child lock, End of cycle.

Program Details: Auto (sensors adjust time/temp), Intensive (70°C for pots), Eco (50°C, energy-saving), Quick (30 min for lightly soiled), Glass (40°C for delicate), Delicate (40°C for fine china). Settings: Water hardness (1-5), Rinse aid level (1-5), Buzzer on/off, Reset to factory defaults.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

1. Scrape off large food residues; no need to pre-rinse.
2. Lower rack: Place plates, pots, pans. Use fold-down tines for larger items.
3. Upper rack: Place glasses, cups, bowls. Adjust height if needed.
4. Cutlery basket: Place knives, forks, spoons with handles down for safety.
5. Ensure spray arms can rotate freely; do not block with large items.

Tip: Refer to loading diagrams in manual for best results. Do not overload.

Using Wash Programs

Select program based on load type and soil level.

1. Turn on: Press ON/OFF.
2. Select program: Press program button until desired icon lights.
3. Add options: Press Delay Start to set timer; press Half Load if applicable.
4. Start: Close door firmly; press Start/Pause. Cycle begins.
5. Pause/change: Press Start/Pause to stop; open door to add forgotten items.
6. End of cycle: Buzzer sounds (if enabled). Open door slightly to aid drying.

WARNING! Do not open door during high-temperature cycles; steam may cause burns.

Care & Maintenance

Regular maintenance ensures longevity and performance.

1. Clean filter: Twist and lift out filter assembly; rinse under tap weekly.
2. Check spray arms: Ensure holes are not clogged; rotate manually.
3. Refill salt: When salt indicator lights, add salt to container (only when dishwasher is off).
4. Refill rinse aid: When rinse aid indicator lights, fill dispenser.
5. Exterior cleaning: Wipe control panel and door with damp cloth; do not use abrasive cleaners.
6. Run cleaning cycle: Monthly, use dishwasher cleaner or run empty on Intensive program with 1 cup vinegar in bottom.

CAUTION! Unplug before any maintenance. Do not touch heating element.

Safety Information

Read all safety instructions before use.

• This appliance is for household use only.
• Connect to grounded outlet; do not use extension cord.
• Keep children away from open door and detergent dispenser.
• Use only dishwasher detergents, salt, and rinse aid.
• Do not wash items soiled with flammable substances.
• If malfunction occurs, disconnect power and contact service.

WARNING! Risk of electric shock. Do not immerse appliance in water.

Regulatory Information

This appliance complies with EU Directives 2014/35/EU (Low Voltage), 2014/30/EU (EMC), and 2009/125/EC (Ecodesign). Waste disposal: Do not dispose with household waste. Use separate collection facilities. For support, visit www.beko.com or contact local service center.

Troubleshooting

Reset: Unplug for 5 minutes, then reconnect.

Service: Contact authorized Beko service center. Do not attempt repairs yourself.