Beko Dishwasher DIN26410 Manual

The Beko DIN26410 is a freestanding dishwasher featuring 14 place settings, an A++ energy rating, 5 wash programs (including Intensive, Eco, and Quick), delay start, half load option, child lock, water softener, and salt/low rinse aid indicators. It operates on 220-240V, 50Hz. Below are key sections for safety, features, installation, setup, operation, maintenance, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Detergents & Additives 8. Programs & Cycles 9. Care & Maintenance 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control panel with digital display, upper and lower baskets, cutlery basket, filter system, detergent dispenser, salt container, rinse aid dispenser.

Feature	Description
Capacity	14 standard place settings
Energy Rating	A++ (Energy Efficient)
Water Consumption	Approx. 9.5 liters per cycle (Eco program)
Noise Level	49 dB (Quiet operation)
Delay Start	1 to 24 hours
Child Lock	Prevents accidental program changes
Half Load Option	Reduces water and energy for smaller loads
Water Softener	Adjustable for different water hardness levels
Display	Digital with remaining time and status indicators
Dimensions (HxWxD)	85 x 60 x 60 cm

Installation

Unpack and inspect contents. Position near water supply, drain, and power outlet.

Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
Connect drain hose: Ensure proper height (40-100 cm from floor) to prevent siphoning.
Level the appliance: Adjust feet for stability.
Plug into grounded power outlet (220-240V, 50Hz).

WARNING! Ensure water and electrical connections are performed by a qualified technician. Do not bend or kink hoses.

First-Time Setup

Before first use, run an empty wash cycle.

Remove transport safety materials: Check interior for any packing strips.
Fill salt container: Add up to 1.5 kg of special dishwasher salt (first use may require water).
Fill rinse aid dispenser: Fill to MAX line with rinse aid.
Set water hardness: Use control panel to match your local water hardness (1-5).
Run initial cycle: Select Intensive program without dishes to clean interior.

CAUTION! Use only dishwasher salt in the salt container. Do not use table salt.

Specifications

Model: DIN26410
Type: Freestanding Dishwasher
Place Settings: 14
Energy Class: A++
Programs: 5 (Intensive, Eco, Normal, Quick 30', Delicate)
Water Pressure: 0.03 - 1 MPa
Power Supply: 220-240V, 50Hz
Power Consumption: 0.78 kWh per cycle (Eco program)
Weight: Approx. 42 kg

Controls and Settings

Control Panel: POWER ON/OFF, PROGRAM SELECTION knob, DELAY START, HALF LOAD, CHILD LOCK, START/PAUSE.

Display Icons: Salt indicator, Rinse aid indicator, Remaining time, Program progress, Child lock active.

Program Selection: Turn knob to choose program. Delay Start: Press button, then use +/- to set hours (1-24). Half Load: Reduces resource use for smaller loads. Child Lock: Press and hold for 3 seconds to activate/deactivate. Water Hardness Setting: Accessed by holding PROGRAM and DELAY buttons for 5 seconds.

Loading the Dishwasher

Upper basket: For glasses, cups, saucers, small plates. Lower basket: For plates, pots, pans. Cutlery basket: For utensils (handles down).

Scrape off large food residues; no need to pre-rinse.
Load dishes facing center, ensuring they do not block spray arms.
Place delicate items in upper basket.
Load cutlery mixed for better cleaning.

Tip: Refer to loading diagrams in the manual for optimal arrangement.

Using Detergents & Additives

Use only dishwasher-specific products.

Detergent: Fill main dispenser with powder, tablet, or gel. Use amount according to water hardness and soil level.
Rinse Aid: Fill dispenser to MAX line; adjust dosage level (1-5) via control if needed.
Salt: Fill salt container only when indicator light illuminates.

WARNING! Do not mix different detergent types. Keep all additives out of reach of children.

Programs & Cycles

Select program based on load type and soil level.

Program	Temp (°C)	Duration	Best For
Intensive	70	~150 min	Heavily soiled pots, pans
Eco	50	~200 min	Normally soiled dishes, energy saving
Normal	65	~120 min	Daily use, mixed load
Quick 30'	40	30 min	Lightly soiled, quick refresh
Delicate	40	~90 min	Glass, china, delicate items

Note: Duration may vary based on water temperature and settings.

Care & Maintenance

Regular maintenance ensures optimal performance.

Clean filters: Remove and rinse under water weekly.
Clean spray arms: Check for blockages monthly.
Wipe door seals: Use damp cloth to remove debris.
Run empty hot cycle: Monthly with dishwasher cleaner to remove grease/limescale.

CAUTION! Unplug before any maintenance. Do not use abrasive cleaners.

Regulatory Information

CE marked. Complies with EU directives for safety (LVD, EMC) and eco-design. Waste electrical products must not be disposed of with household waste. Please recycle according to local regulations. For support, visit www.beko.com or contact your local Beko service center.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dishwasher won't start	Power, door, child lock	Check plug, ensure door closed properly, deactivate child lock.
Poor cleaning results	Loading, filters, detergent	Rearrange load, clean filters, use correct amount of fresh detergent.
Water not draining	Drain hose, filter blockage	Check hose for kinks, clean filter system.
Salt/Rinse Aid indicators on	Low levels	Refill salt container and/or rinse aid dispenser.
Unusual noise	Spray arm, foreign object	Check for items touching spray arm, remove any debris.
Error code on display	Various faults	Consult error code list in manual; try resetting by turning power off/on.

Reset: Turn off at mains for 2 minutes, then restart.

Service: Contact authorized Beko service. Keep model and serial numbers ready.