beko dishwasher DSFN 6530 X manual

The Beko DSFN 6530 X is a freestanding dishwasher with a 13-place setting capacity, featuring an A++ energy rating, 6 wash programs, a half-load option, adjustable upper basket, digital display, delay timer, and child lock. It operates on a standard 220-240V, 50Hz power supply. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Care & Maintenance 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Digital control panel, Upper and lower baskets, Cutlery basket, Filter system, Salt and rinse aid dispensers, Water inlet and drain hoses.

FeatureDescription
Capacity13 place settings
Energy RatingA++
Wash Programs6 programs including Intensive, Eco, Quick, Glass
Half Load OptionReduces water and energy for smaller loads
Delay TimerProgram start delay up to 24 hours
Child LockPrevents accidental program changes
Digital DisplayShows program status and remaining time
Adjustable Upper BasketHeight adjustable for taller items
Salt & Rinse Aid IndicatorsLED alerts for refill
Acoustic SignalAudible alert at end of cycle

Installation

Unpack and inspect contents. Position near water supply, drain, and power outlet.

  1. Connect water supply: Attach inlet hose to cold water tap using supplied connector.
  2. Connect drain hose: Place hose into sink or dedicated drain pipe (max height 1m).
  3. Level the appliance: Adjust feet to ensure dishwasher is stable and level.
  4. Plug into power outlet: Use a properly grounded socket.

WARNING! Ensure water and electrical connections are secure before first use. Do not kink hoses.

First-Time Setup

Before first wash, prepare the dishwasher.

  1. Fill salt dispenser: Remove lower basket, unscrew cap, add 1kg of dishwasher salt, then refill with water until it overflows.
  2. Fill rinse aid dispenser: Open lid on door, fill chamber with rinse aid up to MAX mark.
  3. Run initial empty cycle: Select the Intensive program without dishes to clean interior.
  4. Set water hardness: Consult manual table and set dial inside salt compartment.

CAUTION! Only use dishwasher salt and rinse aid. Do not use table salt.

Specifications

Controls and Settings

Access programs and settings via the digital control panel on the top front of the door.

Buttons: POWER ON/OFF, PROGRAM SELECTION, DELAY START (1-24h), HALF LOAD, CHILD LOCK, START/PAUSE.

Programs: Intensive (70°C, for heavily soiled), Eco (50°C, energy-saving), Normal (65°C, daily use), Quick 30' (30 min, lightly soiled), Glass (40°C, delicate), Soak (pre-wash). Settings: Water hardness (adjust via salt compartment dial), Rinse aid dosage (adjust via dial in dispenser), Acoustic signal on/off.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

  1. Scrape off large food residues; no need to pre-rinse.
  2. Lower basket: For pots, pans, plates, and larger items.
  3. Upper basket: For glasses, cups, saucers, and smaller plates. Height adjustable.
  4. Cutlery basket: Place knives, forks, spoons with handles down (except sharp knives).
  5. Ensure spray arms can rotate freely; do not block them with large items.

Tip: Place heavily soiled items facing the center. Do not overload.

Using Wash Programs

Select program based on soil level and dish type.

  1. Add detergent: Use powder or tablet in the main wash compartment of the detergent dispenser.
  2. Select program: Press PROGRAM button to cycle through options; selected program lights up.
  3. Optional settings: Press HALF LOAD for fewer dishes; press DELAY to set start time.
  4. Start: Close door firmly, press START/PAUSE. Display shows remaining time.
  5. During cycle: Door locks; CHILD LOCK can be activated to prevent interruptions.
  6. End of cycle: Acoustic signal sounds. Wait a few minutes before opening to avoid steam.

WARNING! Only use dishwasher detergent. Do not open door during hot wash phases.

Care & Maintenance

Regular maintenance ensures longevity and performance.

  1. Clean filter: Twist and lift out filter assembly weekly; rinse under tap.
  2. Check spray arms: Ensure holes are not clogged; remove and rinse if necessary.
  3. Wipe door seals and interior: Use damp cloth; no abrasive cleaners.
  4. Refill salt and rinse aid: Refill when indicator lights come on.
  5. Run monthly cleaning cycle: Use a dishwasher cleaner or a cup of vinegar on an empty hot cycle.

CAUTION! Unplug before any maintenance. Do not use sharp objects to clean spray arm holes.

Regulatory Information

This appliance complies with EU Directives 2014/35/EU (LVD), 2014/30/EU (EMC), and 2009/125/EC (ErP). Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist. Check local regulations for disposal. For support, visit www.beko.com or contact your local Beko service center.

Troubleshooting

SymptomPossible CauseCorrective Action
Dishwasher won't startPower/DoorCheck plug and power; ensure door is closed properly.
Poor washing resultsLoading/DetergentCheck loading; ensure spray arms rotate freely; use correct detergent amount.
Water not drainingFilter/Drain hoseClean filter; check drain hose for kinks or blockages.
Error code on displayVarious faultsConsult manual error code list (e.g., E1, E2). Unplug for 5 mins, then retry.
Leaking waterHoses/SealsCheck inlet and drain hose connections; inspect door seal for damage.
Unusual noiseSpray arm/ItemsEnsure spray arm is not hitting dishes; check for small items fallen to bottom.

Reset: Unplug for 5 minutes, then plug back in.

Service: Contact authorized Beko service. Find your local center at www.beko.com.

beko dishwasher DSFN 6530 X manual © - All Rights Reserved 2025