Beko Dishwasher DTC36610W Manual

The Beko DTC36610W is a freestanding dishwasher with a 6 place setting capacity, A++ energy rating, and 5 wash programs. It features a stainless steel interior, digital display, delay timer, child lock, and half-load option. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Stainless steel tub, upper and lower baskets, cutlery basket, detergent dispenser, digital control panel, water inlet and drain hoses.

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

1. Remove transit materials: Take out all packaging and securing bolts from rear.
2. Connect water supply: Attach inlet hose to cold water tap (max pressure 1MPa).
3. Connect drain hose: Place hose into sink or dedicated drain pipe (min height 40cm).
4. Level the appliance: Adjust feet until dishwasher is stable and level.
5. Plug into grounded power outlet.

WARNING! Only connect to cold water supply. Ensure electrical socket is easily accessible after installation.

First-Time Setup

Before first use, run an empty wash cycle.

1. Fill salt container: Remove lower basket, unscrew salt cap, fill with dishwasher salt (first use only).
2. Fill rinse aid: Open dispenser on door, fill to MAX line with rinse aid.
3. Add detergent: Place detergent in main wash compartment of dispenser.
4. Select Intensive program: Close door and start cycle without dishes.
5. Set water hardness: Consult manual to adjust setting based on local water hardness.

CAUTION! Only use dishwasher-specific salt, rinse aid, and detergent. Do not use regular table salt.

Specifications

• Model: DTC36610W
• Type: Freestanding Dishwasher
• Capacity: 6 place settings
• Energy Consumption: 0.95 kWh per cycle (Eco program)
• Water Consumption: 9.5 liters per cycle (Eco program)
• Noise Level: 49 dB(A)
• Power Supply: 220-240V ~ 50Hz
• Power Consumption: 2000W
• Programs: Intensive (70°C), Eco (50°C), Quick (45°C), Glass (40°C), Rinse
• Special Functions: Delay Start (1-24h), Half Load, Child Lock

Controls and Settings

Control Panel: POWER button, Program selector, Delay Start button, Half Load button, Child Lock button, Start/Pause button.

Display Symbols: Program indicator, Time remaining, Salt warning, Rinse aid warning, Door open, End of cycle.

Program Selection: Turn knob to desired program. Delay Start: Press DELAY, use +/- to set hours. Half Load: Press button when loading is light. Child Lock: Press and hold for 3 seconds to activate/deactivate. Starting: Close door firmly, press START/PAUSE.

Loading the Dishwasher

Proper loading ensures optimal cleaning.

1. Scrape off large food residues (no pre-rinsing needed).
2. Lower basket: Plates, pots, pans (facing center).
3. Upper basket: Cups, glasses, small bowls (angled downward).
4. Cutlery basket: Forks and spoons handle down, knives handle up.
5. Ensure spray arms can rotate freely.
6. Do not overload; water must reach all surfaces.

Tip: Place delicate items in upper basket, heavily soiled items facing spray arms in lower basket.

Using Wash Programs

Select program based on soil level and dish type.

Adding Detergent: Use main wash compartment for powder/liquid tabs. Use pre-wash compartment for heavily soiled loads. Close dispenser lid firmly.

Care & Maintenance

Regular maintenance ensures longevity and performance.

1. Clean filters: Remove lower basket, twist and lift out filter assembly, rinse under tap weekly.
2. Clean spray arms: Check for blockages, rinse holes monthly.
3. Wipe door seals: Use damp cloth to remove debris.
4. Descale: Run empty cycle with dishwasher cleaner every 2-3 months if in hard water area.
5. Exterior: Wipe with soft damp cloth, mild detergent if needed.

CAUTION! Unplug before any maintenance. Never use abrasive cleaners or scouring pads.

Safety Information

Read all instructions before use.

• Connect to properly grounded outlet only.
• Do not use extension cords.
• Keep children away from open door (hot surfaces).
• Only use detergent designed for dishwashers.
• Do not wash items soiled with flammable substances.
• Unplug during storms or long periods of non-use.
• Disconnect power before servicing.

WARNING! Risk of electric shock. Do not open door during wash cycle; hot steam may escape.

Regulatory Information

This appliance complies with EU Directive 2014/35/EU (Low Voltage Directive) and 2014/30/EU (EMC Directive). Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist. Check local regulations for disposal of packaging material. For service, contact authorized Beko service center. Manufactured for Beko PLC. Copyright © Beko 2023. All rights reserved.

Troubleshooting

Reset: Turn power off at socket for 2 minutes, then restart.

Service: For persistent issues, contact Beko Customer Support: 0333 207 9710 (UK) or visit www.beko.co.uk