Beko Dishwasher DTC36810W Manual

The Beko DTC36810W is a freestanding dishwasher with a 13-place setting capacity, A++ energy rating, and multiple wash programs. It features a stainless steel interior, digital display, delay start, child lock, and half-load option for efficient cleaning. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Wash Programs 8. Care & Maintenance 9. Safety Information 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Stainless steel tub, upper and lower baskets, cutlery basket, detergent dispenser, digital display, control panel.

FeatureDescription
Capacity13 place settings
Energy RatingA++
Wash ProgramsAuto, Intensive, Eco, Quick, Glass, Half Load
Digital DisplayShows program time, delay start, and status
Delay StartProgram start delay up to 24 hours
Child LockPrevents accidental program changes
Half Load OptionReduces water and energy for smaller loads
Salt & Rinse Aid IndicatorsAlerts when refill is needed
AquaStopLeak protection system
Noise Level49 dB

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

  1. Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
  2. Connect drain hose: Place in sink or connect to waste pipe (min height 40 cm).
  3. Level the dishwasher: Adjust feet to ensure machine is stable.
  4. Plug into grounded power outlet (220-240V, 50Hz).

WARNING! Do not use extension cords. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first use, run a wash cycle without dishes.

  1. Remove transport materials: Take out brackets and securing tapes.
  2. Fill salt container: Use only dishwasher salt; fill until water overflows.
  3. Fill rinse aid dispenser: Open cap and fill to MAX line.
  4. Add detergent: Place powder or tablet in dispenser.
  5. Select Intensive program: Run empty to clean interior and remove residues.

CAUTION! Use only dishwasher-specific salt, rinse aid, and detergents.

Specifications

Controls and Settings

Control Panel: POWER, PROGRAM SELECTION, DELAY START, HALF LOAD, CHILD LOCK, START/PAUSE.

Display Icons: Program time, delay timer, salt/rinse aid indicators, child lock, end of cycle.

Program Selection: Auto (senses soil level), Intensive (heavy soil), Eco (energy saving), Quick (light soil), Glass (delicate), Half Load (small loads). Settings: Delay Start (1-24 hours), Child Lock (hold 3 sec to activate), Half Load (reduces water use).

Loading the Dishwasher

Upper basket: Cups, glasses, small plates. Lower basket: Plates, bowls, pots. Cutlery basket: Knives, forks, spoons.

  1. Scrape off large food residues; no need to pre-rinse.
  2. Load dishes facing center; ensure water spray can reach all surfaces.
  3. Place delicate items in upper basket; secure stemware in holders.
  4. Do not overload; allow space between items.

Tip: Refer to loading diagrams in manual for optimal arrangement.

Using Wash Programs

Select program based on soil level and dish type.

  1. Add detergent: Use tablet or powder in dispenser (max 25g).
  2. Close door: Ensure it latches securely.
  3. Select program: Press PROGRAM until desired cycle lights.
  4. Optional: Set DELAY START if needed.
  5. Press START/PAUSE to begin; display shows remaining time.
  6. After cycle: Wait for end beep; open door slightly to let steam escape.

WARNING! Do not open door during wash; hot steam may cause burns.

Care & Maintenance

Clean filters monthly: Remove lower basket, twist out filter assembly, rinse under tap. Wipe door seals and interior with damp cloth. Use dishwasher cleaner every 2 months to remove limescale.

CAUTION! Unplug before cleaning. Do not use abrasive cleaners.

Safety Information

Keep children away during operation. Do not wash non-dishwasher-safe items (wood, cast iron, aluminum). Use only detergents for dishwashers. Ensure door is closed when not in use to prevent tripping.

Regulatory Information

CE compliant. Meets EU energy labeling regulations. Waste electrical products must not be disposed of with household waste; recycle according to local regulations. For support, visit www.beko.com or contact local service center.

Troubleshooting

SymptomPossible CauseCorrective Action
Dishwasher not startingDoor not closed/powerEnsure door latched; check power outlet; circuit breaker.
Poor cleaning resultsOverloading/detergentLoad correctly; use fresh detergent; clean filters.
Water not drainingDrain hose blockedCheck hose for kinks; clean filter; ensure drain height correct.
LeakingHose connectionsTighten inlet/drain hoses; check door seal for debris.
Noise during washSpray arm obstructedCheck for items blocking spray arm; ensure dishes not touching it.

Reset: Unplug for 5 minutes, then restart.

Service: Contact authorized Beko service center; keep model number ready.

Beko Dishwasher DTC36810W Manual © - All Rights Reserved 2025