beko dishwasher DVN04X20W manual

The Beko DVN04X20W is a freestanding dishwasher with a 14-place setting capacity, A++ energy rating, and multiple wash programs. It features a stainless steel interior, digital display, delay start, child lock, and half-load option for efficient cleaning. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

Features at a Glance

Key components: Stainless steel tub, upper and lower baskets, cutlery basket, detergent dispenser, digital control panel, water inlet and drain hoses.

Installation

Unpack and inspect contents. Ensure location is level and near water/drain connections.

1. Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
2. Connect drain hose: Place in sink or connect to waste pipe (min height 40 cm).
3. Level the dishwasher: Adjust feet until unit is stable and level.
4. Plug into grounded power outlet.

WARNING! Do not use extension cords. Ensure water connections are tight to prevent leaks.

First-Time Setup

Before first use, run a wash cycle without dishes.

1. Add salt: Fill salt container in bottom of tub (use only dishwasher salt).
2. Add rinse aid: Fill rinse aid dispenser in door.
3. Select program: Choose Intensive cycle at highest temperature.
4. Start: Close door and press Start/Pause.

CAUTION! Use only detergents and additives designed for dishwashers.

Specifications

• Model: DVN04X20W
• Type: Freestanding
• Capacity: 14 place settings
• Energy Consumption: 0.83 kWh per cycle (Eco program)
• Water Consumption: 9.5 liters per cycle (Eco program)
• Noise Level: 49 dB(A)
• Dimensions (HxWxD): 85 x 60 x 60 cm
• Voltage: 220-240V ~ 50Hz
• Power: 2100 W
• Inlet Water Pressure: 0.03 - 1 MPa

Controls and Settings

Control Panel: Power On/Off, Program Selection, Delay Start, Half Load, Child Lock, Start/Pause.

Programs: Auto (55-65°C), Intensive (70°C), Eco (50°C), Quick (45°C), Glass (40°C).

Settings: Delay Start (1-24h), Child Lock (press and hold Start for 3 sec), Salt/Rinse Aid refill indicators, Half Load (for lower basket only). Display shows remaining time, program stage, and alerts.

Loading the Dishwasher

Upper basket: Cups, glasses, small plates. Lower basket: Plates, bowls, pots. Cutlery basket: Knives, forks, spoons.

1. Scrape off large food residues.
2. Load items facing inward, ensuring they do not block spray arms.
3. Place delicate items in upper basket.
4. Secure long utensils in cutlery basket.

Tip: Do not overload; allow water to circulate freely.

Using Wash Programs

Select program based on soil level and dish type.

1. Add detergent: Fill main dispenser (for pre-wash and main wash).
2. Select program: Press Program button until desired cycle lights up.
3. Optional: Set Delay Start or Half Load.
4. Start: Close door and press Start/Pause.
5. After cycle: Wait for cycle end beep; open door slightly to let steam escape.

WARNING! Do not open door during wash cycle; hot water may cause burns.

Care & Maintenance

Clean exterior with damp cloth. Monthly: Clean filter assembly and spray arms.

1. Remove filter: Twist and lift out.
2. Rinse under warm water to remove debris.
3. Check spray arms for blockages.
4. Run empty cycle with dishwasher cleaner monthly.

CAUTION! Unplug before maintenance. Do not use abrasive cleaners.

Safety Information

Keep children away from open dishwasher. Do not lean on open door. Only use detergent designed for dishwashers. Ensure power cord is not damaged.

Regulatory Information

CE compliant. WEEE directive: Do not dispose with household waste. For disposal, contact local authorities. Energy label according to EU regulation 1059/2010. For support, visit www.beko.com or contact local service center.

Troubleshooting

Reset: Unplug for 5 minutes, then restart.

Service: Contact authorized Beko service center; www.beko.com