Beko Dishwasher Manual

The Beko Dishwasher is a modern, energy-efficient appliance designed for convenient and effective dish cleaning. It features multiple wash programs, adjustable racks, delay start, child lock, and water/energy-saving options. This manual covers safety instructions, installation, daily use, program selection, maintenance, and troubleshooting to ensure optimal performance and longevity of your appliance.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Loading the Dishwasher 7. Using Detergents & Rinse Aid 9. Care & Cleaning 10. Regulatory Information 11. Troubleshooting

Features at a Glance

Key components: Control Panel, Upper and Lower Racks, Cutlery Basket, Filter System, Detergent & Rinse Aid Dispensers, Spray Arms, Water Inlet/Outlet.

Feature	Description
Control Panel	Digital display with program selection buttons
Wash Programs	Auto, Intensive, Eco, Quick, Glass, Rinse
Adjustable Racks	Height-adjustable upper rack for tall items
Delay Start	Program start delay up to 24 hours
Child Lock	Safety lock to prevent accidental program changes
Half Load Option	Eco wash for fewer dishes
Filter System	Self-cleaning coarse and fine filters
Salt Indicator	Light alerts when water softener salt is low
Acoustic Signal	Audible end-of-cycle signal (can be turned off)
Energy Rating	A+++ for high energy efficiency

Installation

Unpack and inspect contents. Ensure location is level, near water/drain connections.

Connect water supply: Attach inlet hose to cold water tap (max pressure 1 MPa).
Connect drain hose: Ensure proper height (40-100 cm from floor) to prevent siphoning.
Level the appliance: Adjust feet using a wrench for stability.
Plug into grounded power outlet (220-240V, 50Hz).

WARNING! Do not use extension cords. Ensure water connections are tight to prevent leaks. Follow local plumbing codes.

First-Time Setup

Before first use, run an empty wash cycle with detergent.

Remove shipping materials: Take out all interior packaging and transit bolts.
Fill salt dispenser: Unscrew cap, add water softener salt (first use only), then fill with salt.
Fill rinse aid: Open dispenser, fill to MAX line, adjust setting (1-6).
Select language: Press and hold START for 3 seconds to cycle through display languages.
Run initial cycle: Select Intensive program without dishes to clean interior.

CAUTION! Only use dishwasher salt in the softener. Do not use table salt.

Specifications

Capacity: 14 place settings.
Water Pressure: 0.03 - 1 MPa.
Power Supply: 220-240V ~ 50Hz.
Power Consumption: 0.78 kWh per cycle (Eco program).
Water Consumption: 9.5 liters per cycle (Eco program).
Noise Level: 49 dB(A).
Dimensions (HxWxD): 85 x 60 x 60 cm.
Net Weight: 45 kg.
Programs: Auto (60°C), Intensive (70°C), Eco (50°C), Quick (45°C), Glass (40°C), Rinse.
Special Functions: Delay Start (1-24h), Half Load, Child Lock, Extra Dry.

Controls and Settings

Access programs via control panel buttons. Display shows remaining time, program, and status icons.

Buttons: POWER, PROGRAM (cycle through options), DELAY START, HALF LOAD, CHILD LOCK, START/PAUSE.

Program Selection: Press PROGRAM repeatedly to choose. Delay Start: Press DELAY, then use +/- to set hours. Child Lock: Press and hold CHILD LOCK for 3 seconds (to unlock, repeat). Rinse Aid Setting: Adjust dial inside dispenser (1=lowest, 6=highest). Salt Refill: Salt indicator light illuminates when low; add to dispenser until full.

Loading the Dishwasher

Proper loading ensures optimal cleaning and drying.

Scrape off large food residues; no need to pre-rinse.
Lower rack: Pots, pans, plates, bowls. Face soiled surfaces toward center.
Upper rack: Glasses, cups, saucers, small bowls. Secure stemware with holders.
Cutlery basket: Place knives, forks, spoons with handles down (except sharp knives).
Adjust upper rack height: Lift levers on both sides to raise/lower for tall items.

Tip: Do not overload. Ensure spray arms can rotate freely. Place plastic items on top rack only.

Using Detergents & Rinse Aid

Use only dishwasher-specific detergents and rinse aids.

Detergent dispenser: Fill main compartment (for wash cycle) and pre-wash compartment (if heavily soiled).
Detergent types: Tablets, powder, or gel. Follow manufacturer dosage.
Rinse aid: Fill dispenser; adjust setting based on water hardness (higher number for hard water).
Salt: Only needed in hard water areas. Fill until water overflows, then screw cap tightly.

WARNING! Do not use hand soap, laundry detergent, or vinegar. Keep detergents out of children's reach.

Care & Cleaning

Regular maintenance ensures efficiency and prevents odors.

Clean filters weekly: Remove lower rack, twist filter assembly counterclockwise, rinse under water.
Clean spray arms monthly: Remove by unscrewing caps, clear any debris from holes.
Wipe door seals: Use damp cloth to remove food particles.
Descale periodically: Run empty cycle with dishwasher cleaner or citric acid (if in hard water area).
Exterior: Clean with mild soap and soft cloth.

CAUTION! Unplug before cleaning. Do not use abrasive cleaners or scouring pads.

Regulatory Information

This appliance complies with EU Directive 2014/35/EU (Low Voltage), 2014/30/EU (EMC), and 2009/125/EC (Ecodesign). Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist. Check local regulations for disposal. For support, visit www.beko.com or contact your local service center.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Dishwasher won't start	Power, door, child lock	Check plug; ensure door closed properly; deactivate child lock.
Poor cleaning results	Loading, detergent, filters	Rearrange load; use correct detergent amount; clean filters.
Water not draining	Drain hose clogged/kinked	Check hose for blockages; ensure proper installation height.
Leaking water	Door seal, hose connections	Inspect door seal for debris; tighten water inlet connections.
Unusual noise	Spray arm obstruction, loose items	Check for utensils blocking spray arm; secure items in racks.
Salt indicator stays on	Salt dispenser empty	Refill with dishwasher salt; run short rinse cycle.
Dishes remain wet	Rinse aid empty, program selection	Refill rinse aid; select Extra Dry option or higher temperature program.

Reset: Unplug for 5 minutes, then restart. If error codes appear (e.g., E1, E2), consult manual.

Service: Contact authorized Beko service at www.beko.com or call local service number.