Beko Dishwasher Manuals

Most Common Error Codes (All Models)

• E01: Overflow / leak detected – water in base pan; tilt machine back 45° to drain excess water & reset float switch; check for leaks, clean filters & drain hose.
• E02: Water inlet / shortage issue – check water supply valve is fully open; ensure no kinks in inlet hose; clean inlet filter; verify water pressure.
• E03: Heating error – water not reaching set temperature; check heating element continuity; inspect thermistor (NTC); may require professional repair.
• E04: Water filling / level issue during cycle – check stored water sensor or diverter valve; inspect for blockages or faults in pressure system.
• H2: Turbidity sensor error – sensor fault affecting water clarity detection; clean sensor area or check for debris; impacts auto programs.
• H4: NTC / temperature sensor error – thermistor failure; dishwasher cannot read temperature accurately; usually needs replacement by technician.

Advanced / Recent Models (2023–2026)

• H3: Diverter valve error – improper water direction to spray arms; check valve operation and positioning.
• H5 / H6: Water inlet faults (continuous or interrupted) – inspect inlet valve, triac on control board, or hose issues.
• H7: Heating fault – element or control issue; check for airlocks, ensure proper water level; may need reset or service.
• P1: Overflow / no water into appliance – similar to E01; check float switch and drain.
• P3: Heater fault – persistent heating issue; professional diagnosis recommended.
• P4: Turbidity / clarity sensor fault – clean or replace for better auto-cycle performance.

General Dishwasher Specific

• Not cleaning well: Clean spray arms, filters (including EverClean if present); use quality detergent & rinse aid; avoid overloading.
• Not drying properly: Ensure rinse aid dispenser is full; select programs with extra dry; check zeolite or condenser (model dependent).
• Noisy / vibration: Level the appliance using adjustable feet; ensure even loading; check for loose spray arms or foreign objects.
• Not starting / no power: Verify door is fully closed & latch engaged; reset by unplugging 10 min; check household circuit breaker.

Safety note: Always unplug the dishwasher before cleaning filters, inspecting hoses, or any maintenance. Do not bypass safety devices like the float switch. For electrical faults or persistent errors, contact a qualified technician.